How can I stop cold air from coming down the chimney?
We have gas logs in what was once a wood-burning fireplace. We don't use the logs anymore because they seemed to suck the heat out of the entire downstairs. The log installer fixed the damper so that it won't close completely, apparently a safety feature in case you light the logs without opening the damper. Now cold air comes down the chimney and our feet get so-o cold. Any suggestions for sealing up the chimney?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How can I stop the cold air from coming through electrical outlets?
The facings -trim-around the doors allow cold air to come in. How can I get these drafts stopped
How do I prevent cold air from coming in behind my kitchen sink?
I have cold air that comes in from behind kitchen sink an counter. There is a gap between counter an the wall.
My mom put an old pillow into a plastic bag, and stuffed it up the chimney of her wood fireplace. I think this would work for your situation, as well. As long as you don't use the fireplace!!
Foam insulation helps stop drafts from entering through the fireplace. Cut a piece of thick insulation foam -- the type sold in large sheets for construction projects (that is the stiff type) -- to fit the opening of the fireplace like a pull-out panel. Cover the piece with a decorative fabric that matches the room's decor, securing the fabric with pins on the back side for a visually pleasing way to keep the cold air away.
If you want to seal the chimney what was the point of having the damper adjusted to not close. People have used foam sheets and made panels to put up the chimney. There are inflatable bags that are suffed up the chimney and blown up. Any way to cover the opening that will fit. If you forget to remove anything and fire up the logs is no different than having a closed damper. Just get the damper fixed to close properly.
We had two leaky chimneys too. I tried making a wooden cover/ screen but that was ineffective.
Two other options were studied.
We looked at the chimney balloons as an option on Amazon but with them costing $50 and needeing to be removed and replaced with fireplace use -we decided to purchase a pull down option that works marvelously. Our roofline was not very steep so our situation for a diy installation was quite wasy.
https://www.rockfordchimneysupply.com/chimney-dampers/top-sealing-chimney-damper-caps
The balloons are available in many sizes, you would need measurements to determine your size and cost.
Fireplace dampers are inefficient due to warping and misalignment from frequent heating and cooling. A bad damper can cost you up to 30% more on your heating bill. Your fireplace damper is releasing your indoor heat and letting in cold outside air! The Chimney Balloon is a inflatable blocker that prevents drafts from a chimney caused by a broken, warped, or missing flue damper. It even works in chimneys that have no damper! The Chimney Balloon stops this heat loss by acting as a chimney blocker to insulate your fireplace and save you money, heat, and comfort.
https://www.rockfordchimneysupply.com/chimney-balloon.php
https://www.amazon.com/Chimney-Balloon-Inflatable-Blocker-Medium/dp/B000MIO394
MEASURE THE OPENING inside the chimney just above the logs. Cut a large piece of cardboard from a box & with duct tape, tape the cardboard over the hole going up the chimney. It shouldn't be visible from the front when company comes over. Only you will know it's there because it'll be inside the inner edge inside the chimney. We did this for ours too. Cheap & effective.
We bought 2 pieces of plexiglass to cover the opening that we slide behind the screen when weāre not using the fireplace. Not visible and easy to slide in and out.
We also used a piece of plexiglass to close off our chimney, it was operational at 1 time but the bricks and mortar part above the roof began to degrade, we had it taken down and the roof patched.
We had the same situation as you. Wood to gas and found the fireplace sucked gas like mad. So we changed it to electric. You can shut the vent completely and the fire is pretty and gives out a little heat. Works for us.