How ia the watering can/ with lights pouring out looking like water,
I've seen the project where they use a watering can and has lights pouring out looking like water. Need instructions
Related Discussions
How do I make shiny galvanized steel look dull like the watering can?
I am planning to use this galvanized bucket to store my hose & the watering can as a planter. Is there something I can do to the shiny upper part of the bucket to ma... See more
How to use unused bathtub for storage
We do not use our bathtub, so I was wondering if anyone had any ideas on how to turn it into storage--shelves or something--without too much effort. Thanks
Can I use scented epsom salts for plants?
I've read to use empson salt in your plants, but my question is can I use scented Epsom salts?
How can I prevent my "full of yard waste" paper bags from the rain?
I don't have any place to store them once full, inbetween biweekly pick-ups. My yard is large, many bags, and not in a position to fully compost yet. Thanks!!!
Any advice for toning down a canvas painting?
I have a painting done on canvas that is a bit too bright. I would like to tone it down some. I was thinking of spreading on a light gray stain gel. Do you think t... See more
How to do MDF flooring in the Bathroom?
I want my bathroom flooring with MDF wood. Some of my friends suggested me this. Actually I have less idea on this. Even I don't know the basics difference between HD... See more
Here's another one for you to look at: https://unskinnyboppy.com/2018/05/diy-fairy-lights-pouring-from-a-watering-can/
Hi Diane, here is a little video that may help
https://www.youtube.com/watch?v=xtO5Kl4b5-4
I actually make and sell these. I use solar fairy lights (the copper wire kind) and metal watering cans with a removable spray nozel. You have to make a few holes in the nozel bitter using a screw driver. I do the one in the middle and four or five evenly spaced a couple of rounds from the center. thread the entire length of lights through the spout starting inside the can. I measure out about 3-3 1/2 feet of lights and fold in half. I do this again for as many strands as I have enlarged holes. Then I fasten them together at the base, where the wire meets the plastic coated wire. Thread each looped section through the holes in the nozel, CAREFULLY, you don't want to break or cut a wire. Push all of the base into the nozel and screw back onto the spout. Hang by the handle. I hang mine on a shepherds hook and attach the solar pad to the hook with zip ties. Make sure the solar pad is on and let charge in the sun during the day. The results are quite pretty. Good luck.