What type of light switch is this?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
What type of light switch is this?
The previous owner installed this basement light switch. The switch is the first switch as you walk downstairs. This must be a timer switch. We can not figure out how... See more
What can I use for a flat on/off light switch that won't yellow?
We built our house 15 years ago. We had flat on/off light switches installed. All of them have yellowed/discolored and are no longer white. One dimmer switch that ... See more
Craig,
Three terminals (the screws) indicates a 3-way switch. If there is a terminal on the unseen side, then it is a 3-way switch. Also, there should be a red wire if it is 3-way. I also can't see inside the box. Does this switch control two light fixtures? Is that why there are three black wires? This switch may not be wired correctly.
Can't tell from the picture. Does this switch turn a light on and off with another switch? If it does it's a three way. If not it's a standard switch. It also looks like it's not wired properly.
My husband took electricity in the army (is not certified but does all our electrical needs) and he says it is a 3 way
Then it's just a standard switch. Three way switches can't be connected to operate only one fixture.
The third wire connected to the switch is a mystery. It looks like you have power coming into the box (one black) and then power to the light fixture (second black). Even if this box powered another receptacle or device, that black would be wire nutted in the box, not connected to the switch unless the switch was meant to control something else. I am assuming the neutrals (white wires) are in the box and we just can't see them. Another way to tell if it is a 3-way switch is there are no "On" or "Off" markings.
That would make sense. Craig, if you have not rewired the new switch yet, don't do it the way it was by backstabbing that third black wire. Wire nut the two hot black wires and pigtail them to the screw terminal. When you shut the breaker off to change the switch, figure out what else is on that circuit and what that third wire might go to. Make sure it is accurately recorded on your panel schedule.