How do I build a wall unit using store-bought cabinets?
how to build a wall unit using store bought cabinets
Related Discussions
How to replace a toilet seat?
I need advice on how to replace a toilet seat, please. What do I need to know when looking for a new one?
How can I fill this wasted space?
I have a raised ranch house, in the foyer above the door there’s so much wasted space. Is there any way I could put my television or something in this area?? Any ot... See more
Is it ok to have the back of your sofa facing the entrance of house?
When you walk into my home the dining area is on the left and in front of you is the living room. The back of my sofa faces you because there’s no where else to put... See more
Den conversion ?
I have a space that I’d like to turn into bedroom and bathroom. This would give me a desperately needed third room. The room is less than 200sqft and I need advice ... See more
Can I keep electronics on top of my radiator cover during the winter ?
Will it ruin my electronics what would be the best way to solve this issue Should I put a tv stand in front of it or try and build a shelf over it or would it be f... See more
How do I make my recliner more comfortable?
My disabilities (both hips and knee replaced, bad back and neck and thus 295lbs) make my recliner the best bed for me. It seems like I tried everything I can think o... See more
Suggestions for Large and deep Alcove/niche in living room ?
Need help with how to decorate around a tv in this space. It's a deep Alcove next to the fireplace that goes from the floor to the ceiling!
This tutorial may help https://www.hometalk.com/diy/build/furniture/diy-office-built-ins-9302586
DIY Office Built-Ins
The linked article is a great one. Remember what ever you build, make sure you anchor so that it won't topple.
The trim will make the difference. It will cover seams and unify the parts. Stain the trim to match the cabinets. Best wishes! Jewell
Thank you !!
They should have a plywood stabilizing sheet on the back, because they’re made with nailer strips, not continuous structural backs.
Screw the plywood into those nailer strips.
Thanks for the good advice !