How can I repair a large resin bear?
I have a large resin bear. He has been knocked over and hole has appeared in his hind qtrs. No pieces left as they where discarded I or lost in house move. How can I fix this and make it look like fur.
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How can I repair an outdoor resin fountaint that is cracking?
Is there a spray for the outside of resin fountains,as mine is cracking
How can I repair a large chip from my porcelain kitchen sink?
I set a hot pan on the divider of my porcelain kitchen sink and a large chunk of the porcelain cracked and broke out (3"x1" piece). I've heard there are patch kits; ... See more
A picture would allow us to give you more detailed and relevant responses. Thanks!
Hi Karen, I believe a similar question has been asked before with some good answers. Here's the discussion. https://www.hometalk.com/diy/repair/appliances/q-what-is-the-best-way-to-patch-a-hole-in-a-resin-statue-33679552
What is the best way to patch a hole in a resin statue
First you need a backing on the inside of the hole for any repair. Cut a disk out of some thin cardboard slightly larger than the hole. Use a long nail and pierce the nail though the center of the disk leaving the nail in. Fold the disk slightly and force it gently in the hole with the nail head down. Use some liquid super glue and saturate the disk. Pull up on the nail to glue the disk to the inside of the hole. Hold it tight for the glue to dry. Then you can either push the nail inside or pull it out. Now you can use some auto body filler or two part epoxy putty to cover the hole. Let it dry completely. Sand it smooth with the surface and drill you new hole.
If the hole is irregular fill the cavity with aluminum foil below the surface. Then fill the hole with auto body filler. As the filler hardens it goes into a rubbery stage. That is when you carve it and texture it to look like fur. You will need to experiment with different objects to mimic the fur texture. ou have quite a bit of time before it starts to harden solid. Once hardened you can use craft paint to match the colors.
Cut out a "patch" from a milk jug or water/pop bottle. Glue it in place with a strong glue like Super Glue or Gorilla Glue. Then paint it to match the bear.
Try a piece of card board then hot glue to fill in then cover with fur
Resin fur-shapes or flocked fur or?
Patch with spackling if it is resin. While it is still damp use a toothbrush or small toothed comb to make marks like fur then match paint to the existing color. Cover with a few coats of matte finish polyurethane in spray or brush on.