removing non-paintable silicone caulking from fiberglass tub surround
I would appreciate any recommendations from the "hometalk" team?
-
Peace Painting Co., Inc. on Jan 15, 2012Uggh, MJ that's a toughy. Not ever having done that exact procedure, scraping and removing the residual caulk with solvent sounds like the best approach. What solvent? Perhaps toluene, MEK or acetone. You can also try a paint stripper. After scraping all that is possible, try using an extra fine scotch-brite pad with the chemical of choice. You will need the correct chemically resistant gloves and we use respirators when using these chemicals that will make you sick. The disclaimer is, try this first in a discrete location. Silicone caulk is one of the banes of our existence /-: Best, CharlesHelpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Jan 15, 2012You need to be careful using chemicals. Check a very small spot elsewhere before you try on larger areas. The Gel Coat on the tub may soften and dull as the result. You may only be able to remove this with a tiny scraper and some very careful work. But as Charles suggested a fine scotch-brite pad should be able to help remove the tiny amounts left. To protect the tub and surrounding area when cleaning, I would put down some painters tape right next to where your cleaning, scrubbing etc. This way you lower the risk of scratching or dulling the finish outside of the caulking zone.Helpful Reply
-
-
Brenda D on Jan 15, 2012there is a product called GOOFOFF. no kidding it works for everything. even paint in carpetHelpful Reply
-
-
Dan's of Central Florida, Inc. on Jan 15, 2012I've found that a thin rag around the scraping end of a putty knife it usually enugh the allow you to slice under those little bits yet do no damage to the tub. You don't have to get every little bit off of there. You will, or should, caulk along that same edge with a paintable tub caulk. The new caulk will cover and seal in the old tiny leftover bits. If some of the old sticks out in places, just concentrate on removing those sections better instead of all of it.Helpful Reply
-
-
3po3 on Jan 15, 2012I think Dan has a good solution for you. If you want to keep tackling it, I have had luck in the past with mineral spirits, but as Woodbridge said, it is worth testing in a small inconspicuous spot first.Helpful Reply
-
-
Patricia Fluharty on May 24, 2015I used a hair dryer on high setting. Hold over area for a few seconds and it should soften it enough to pull out. Just be careful with the electrical cord around water.1 marked as helpful Reply
-
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How to remove silicone residue from fiberglass tub?
I removed the shower door from my fiberglass tub and cannot remove the silicone residue- I have scraped and scrubbed and bleached and used every cleaner out there but... See more
Tile backsplash when there is existing countertop backsplash
We are thinking about how to add a backsplash to our kitchen. Unfortunately when we had our countertops installed we ordered a small backsplash that comes part way up... See more