How to replace glass or plexiglass to a cabinet?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How can I replace glass shelves in a curio cabinet?
So was putting glass shelves in and the 5th one slipped breaking all below 😢 suggestions on replacing? Think I am over glass !!
Brr! Drafty windows- how to cut the draft?
I have 3 sets of windows configured like this...very drafty, How to you winterize them? There is nothing in the corner to stick tape to. Thank you
A picture at least of the area inside and out where the glass would go would help. Do you know how the glass was secured?
There should be some sort of molding holding the glass in the door...if not you can add it. You will need to CAREFULLY ..patience is essential here... remove the molding from one side of the "window" opening in the door.. a putty knife would work here r(one side acts as a stop to keep the glass from falling thru) Note: there may be a rabbet/ notch milled into the door to hold the glass. Measure the opening and go to your local hardware (some will cut it for you) or glass and mirror place and get new glass cut to fit.. Put into your doors and replace the molding using a brad nail-er/ stapler or small finishing nails. Remember: PATIENCE
My answer starts with a question. Is it flat glass or curved? Flat glass is pretty easy. First of course you will want to remove any remaining glass and then carefully remove the retaining hardware. The retaining hardware could be any of several types so just look and see what you have.
Now you will have to get a replacement glass and this shouldnt be too hard. You should be able to find a place where they will cut the glass to measure. Just be sure that you measure CAREFULLY and allow perhaps 1/8”-1/4” so that the glass will slip in easily. Use some painters tape to hold the glass while you restore or replace the retaining hardware and you should be able to step back and feel proud.
Call a local glass and mirror place, explain what you are looking for and ask for guidance on what measurements you need to take, have them cut a piece of glass to fit. Can you tell how the glass was originally held in place? for example, was there a frame in the inside of the door? If so, carefully pry off the top and one side of the frame, put the glass in and replace the two pieces. It may have been held in place with a putty or adhesive, or there may be clips to hold the glass in place...if you still have some glass in the piece, try to see how that is held together.....I have no doubt that you can do this yourself
You may even be able to unscrew the door hinges and take the doors to a glass store, and they can out them in for you.