Would redwood planks make good counter toping and how would you seal i
Related Discussions
Can I ask Home Depot to cut my wood?
I'm seriously considering making this twisty side table that I fell in love with here on Hometalk (By Chasing A Dream), but cutting the wood is a bit too ambitious fo... See more
What to do with our livingroom ceiling?
We took the old popcorn ceiling off in our livingroom and thought we could just paint it. We fixed some hairline cracks where the joint in the sheetrock are, primed a... See more
What type of hinges are used on the top of this folding table?
Does anyone know what type of hinges are attached to the top of this folding table? The legs fold in toward the back then the top folds down flat against the legs.
How would I be put on these wheels ?
I am planning on doing a mobile wood bench using 2x4. I have these wheels but have no clue to put them on
Sealing/smoothing crate wood
I am turning the sides of an old wooden crate into a coffee table top. The wood is similar to pallet wood: unfinished and prone to giving splinters. How might I go ab... See more
How do I make DIY furniture sliders to move heavy furniture?
HOW DO I MAKE FURNITURE SLIDERS TO MOVE HEAVY FURNITURE.Best furniture sliders!Move furniture easily with Round furniture moving kit that Amazon reviewers swear by!
Redwood is pretty, for counter I would use bar top epoxy pour.
Redwood would be beautiful! Bar Top Epoxy would be beautiful as well! Redwood is very rot resistant and it likes to make Paint peel. I would test whatever you use to make sure it’s durable.
😊
not really a recommended counter top for a kitchen
I would do same as with cutting board use oil like olive or something like it
A couple of ways. One would be by treating it like a butcher block, and thoroughly oiling it down. My kitchen table is butcher block. I take either veggie oil, or olive oil, saturate a paper towel. Wipe it down. Let it sit for a bit. Come back and wipe off excess. The other would be clear water based polyurethane. Or water based marine grade polyurethane. Like I said in above post, Don't shake It! Stir gently, it causes bubbles. Use a foam paint brush, keep it wet. Let dry completely, come back with a 400 grit sandpaper and sand away any imperfections. Suck up dust with vacuum cleaner. Wipe down with tack cloth. Repeat.