How do I gel stain a kitchen island?
I'm expecting the arrival of a new mobile kitchen island in a few days. It's a blah maple (but has all the elements that I want/need) and I want to change the color to a more vibrant cherry. I'm sure it must have some sort of finish coating on it...do I need to sand it all off or can I use TSP and then gel stain it?
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
How do I finish a support stud in the middle of my kitchen island?
When renovating our kitchen we took two walls down and discovered a support beam right in the middle of where the island was going to be. The counter top is white qua... See more
How do i stain and seal a kitchen table top that is made of raw pine?
I have an old dining table and want to replace the top with 2x8 boards for a more farmhouse look. Any suggestions on how to stain wood and then seal it?
If it isn't shiny you can probably assume that there isn't a finish on it. But to be sure just get some 150 sand paper and lightly sand it all over where you are going to stain or paint.
I would sand it so the cherry sticks.
Oh shoot! I thought that would be the answer. I think I'll sand it down before we even put it together...that should make it a bit easier to gel stain it once it's built. BTW, the reason I wanted this particular island is because it was the perfect size and comes with a knife holder on the side (instead of a block on top of the island taking up space) and the cost wasn't prohibitive like some are.
Anyway, thank you so much for the feedback Kathleen & Mona.
It depends on the finish and material as to how well it will take the stain. I would either use a fine grit sandpaper or steel wool to rough the surface if you are sure there is no finish (doubtful that is the case) then clean with TSP, denatured alcohol. Then proceed with the new finish.
Even if it has a finish on it you can use a darker gel stain and put it on with a paint brush & drag a clean paint brush thru it & it will look like wood planks. If you plan on cutting on it you will have to use a cutting board. I used this on my laminate kitchen cabinets to make them darker & look like wood.
Thank you, G. I'm gonna see if I can find an inconspicuous spot and give that a try before having to sand everything down. Thanks for taking the time to respond.