How to repair a crack in a concrete statue?
I had a giant elephant ear that I made a concrete form. I used quike crete concrete. I left it cure for 2 days outside and the temperature were in the 90's. I didn't cover it. I made the concrete 1 inch thick. I picked it up and hauled it to its new home in a vechicle. and when I got home it had cracked. any suggestions.
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How to repair an outdoor cement statue
I have two small deer garden statues, the ear and the tail have lost the cement. How can I repair on them? Is there a product out that I can use to reconstruct the ... See more
I would make it thicker and the longer it has to cure the better . 90's may have been a bit too hot . If its' really big support the center when you move it . Once you get it where you want it the ground will support it. I had one that cracked and made it look the like angel wings . I'll post that one soon
For one inch thick you should embed wire mesh or fiberglass mat in it to give strength and support.
Exactly. You make a cement sandwich with the mesh/mat in the middle.
It normally takes a good 30 days for a thicker concrete to cure. Water is the best cure for concrete. To be sure you should of waited and sprayed it with water daily especially in hot weather and cover it with poly for a least 7 days. I like Sakrete high strength mix.I do not know the full measurements of your project L X W X D
Chaz is right, concrete doesn’t dry, it cures for up to 30 days although it has most of it’s strength in a few days. After it initially hardens some people put it in a tub of water and let it cure there. During that time the concrete incorporates water in its crystalline structure. You can cover a piece of plywood with Saran Wrap and let it cure on that. The wire mesh in the middle will hold it together if it does crack again.
After the cracked one you made cures you can put it together with epoxy. If these are for stepping stones put them on a bed of sand to even out the force on them.
Use concrete patch repair gorilla brand buy it @ homedepot comes in a tube cost approx $6.00 a tube.Then to cover the crack repair buy a small can of concrete paint by rustolum.
Repair with a top coat or make a new one. You could try an epoxy like e-6000 to fill the crack or use concrete crack repair in a caulking tube.