Vanity door and drawers makeover?
I have a small bathroom vanity that I want give the door and two drawers a makeover. All three have triple beveled edges and the door has a routered center. I want to give them the shaker look, but not sure how to deal with the beveled edges. Should I just buy the oak wood and start from scratch or use thin pieces of oak wood to cover the beveled edges and make the inside panel with the same thickness wood so that all surfaces are flat? Suggestions are most beneficial.
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
How do I update a large bathroom vanity from the 1960’s?
I have a large bathroom vanity that I would like to update but not sure how to do it. It has two doors that are set far apart with a bit of blank wooden space betwee... See more
Builder grade laminate bathroom vanity...any way to makeover ?
Re-do a builder grade European cabinet laminate bathroom vanity? Ugh...short of replacing...
I’m womdering if you could just reverse the doors (put the beveled fronts to the inside), cover the hinge screw holes with your flat “shaker” type strips and then do the same with the drawer front.
I would cover the whole door and the drawer fronts with plywood, add the shaker wood pieces, then paint or stain.
How about wainscotting? It's thin, inexpensive and easy to apply, just place on top and finish with your desired paint or stain!