I hate to go all through reinstalling this holder if i have to have it replaced to my 'sensitive' brick wall in front of my home. The part that i circled is like an arrow shape that has been worn thin cause of an occasional strong winds that waves the pole.
That looks like an index pin to keep the other part of the flag pole at the desired angle. It seems that the bolt holding the two halves together might be slightly loose. A lock washer under the head of the bolt with the bolt wrench tightened should keep everything in place.
I have a home that someone has put new floor joists in and around the house the knocked the brick out so what should be a crawl space is open. What can I do to seal... See more
As I said, I have a mid-century modern home which needs ceiling repair. I'm a 1950's kind of gal so the style of the repair has to go with the house. It is currently... See more
Can you use a cement board (I.e. Hardie board, Duroc) on top of the original countertop and seal it to get a "cement" countertop? If so, will it be heat resistant?
Our sidewalk is too high and when it rains the water seeps in under the front door of our home. What is the best way to fix this problem? (our entry is also cement)... See more
I have an elevated stamped concrete patio that is crumbling in spots & breaking away from the railing posts. Any ideas how to save it without replacing it?
I had a slight leak that resulted in my painted, I think over wall paper, bedroom ceiling. It's very old plaster perhaps that is still intact but the paint... See more
I removed a cabinet in my bathroom. It was above the sink and counter, up next to the ceiling. After the the cabinet was removed, it revealed a vent hole and a hole... See more
It's time to repair or replac our wood garden walkways. Place view the attached photos then reply with your choice betweenGoing back with treated wood (also... See more
I have a long, curved cement walkway from my driveway to my front door that is developing large cracks. How should I handle/ camouflage these cracks without having... See more
I have barely 2 foot of room in my attic at its peak and I need to get more insulation in there. I think it is impossible to get to the edges to install the baffles.... See more
I am hopefully going to be purchasing this home (I am the secondary but it's possible the primary may walk away). It needs a new roof and I have negotiated this into... See more
I want to use a clear roof for my deck (14 X 20) but I want the light to show through. I am wondering if anyone has had any luck with Plexiglas use for this purpose
Hello AS you can see from the pictures the foundation insulation foam of my house is starting to go up. Can we just cut the part that is protruding and flatten the... See more
Your comment...
You might try placing a small wedge between the pole and arrow piece. Fasten the wedge/spacer with some epoxy.
Thank you
That looks like an index pin to keep the other part of the flag pole at the desired angle. It seems that the bolt holding the two halves together might be slightly loose. A lock washer under the head of the bolt with the bolt wrench tightened should keep everything in place.
Thank you...may it forever wave....LOL
A very good wish.