How do I mud drywall butt joints?
Related Discussions
How do I fix the snapping at the butt joints of my laminated floor?
How do I paint amber colored window glass?
The entry door on our house (on the home when we bought it) is a very sturdy door, well made door, but very ugly. The top half has a diamond grid with amber glass. I ... See more
Painting glass candle holders
What kind of paint should I use to make cake stand.
How to make a balloon garland?
Does anyone know how to make a balloon garland or a balloon arch?
Blackout curtains behind vertical blinds
I have two 6' patio doors, and I want to add blackout curtains to keep the sun/cold out. What is the best way to hang them, and what can I use to push the curtains ba... See more
Cleaning stained china tea cups
I have a set of china that belonged to my grandmother back in the '40's. Most of the pieces are still beautiful except one cup that bears cracks inside with perhaps c... See more
How to clean my kitchen cabinets from grease?
My kitchen cabinets are embarrassingly greasy. Please share your degreasing tips with me so I don't have to cringe every time I glance at my cabinets.
Lay a thin layer of mud down the center of the joint. Add your paper or mesh tape over the mud, centered on the joint, then press and drag your mud knife over the tape to set it. Let dry. Use a larger mud knife and apply mud over the tape. Dry. Repeat. Sand.
Karen's answer if correct.
When 'mudding' you will need to apply fiberglass tape to re-enforce the inside wall corner your making. Once taped, you'll then mud over the tape, allow to dry completely, sand, brush off the dust, and then re-mud until smooth and no sign of tape. Paint surface with primer to seal the surface and then use your favorite paint formula.
Dave,
Finishing butt joints are what separates the novice from the pro.
Start out taping the joint as with any joint. Then, using a 12" knife, spread joint compound vertically to both sides of the joint. Stay about 2" away from the taped joint and bend your knife so the compound (mud) tapers away from the joint. Make sure the mud edge closest to the joint is built up at least slightly about the joint. Let that dry completely. After drying come back with a 4" knife (the one you used to apply the tape) and fill in the resulting middle depression. The idea is to have an ever slight mound about 24" wide or more. If you really want to lose your mind lay a flashlight against the wall and shine the light over your newly "finished" butt joint. If you see a shadow on either side the mud must be built up on the shadow side. Strategic light placement in the finished room helps hide a lot of discrepancies.
There are tons of videos on You Tube that show different methods of hiding butt joints.
Good Luck,
Tim