How do I mud drywall butt joints?
Related Discussions
How do I fix the snapping at the butt joints of my laminated floor?
I am looking for Thanksgiving Crafts, please share ideas?
I'm looking for Thanksgiving craft ideas, particularly the pumpkins made from toilet paper and fabric.I would love it if you could share some of your cute DIY project... See more
How do I make fall leaf luminaries?
I saw someone making gorgeous luminaries with fall leaves, and I want to give it a try. Do you have any ideas on how to make them?
How do I make DIY Thanksgiving decorations?
I would love to see everyone's Thanksgiving decorating ideas. I need some inspiration!
How can I decorate for Thanksgiving with antique rose dishes?
I live in central Oklahoma when should I cut my rose bushes back?
i live in central Oklahoma and need to know when I should cut my rose bushes back and how much. Thank you
Lay a thin layer of mud down the center of the joint. Add your paper or mesh tape over the mud, centered on the joint, then press and drag your mud knife over the tape to set it. Let dry. Use a larger mud knife and apply mud over the tape. Dry. Repeat. Sand.
Karen's answer if correct.
When 'mudding' you will need to apply fiberglass tape to re-enforce the inside wall corner your making. Once taped, you'll then mud over the tape, allow to dry completely, sand, brush off the dust, and then re-mud until smooth and no sign of tape. Paint surface with primer to seal the surface and then use your favorite paint formula.
Dave,
Finishing butt joints are what separates the novice from the pro.
Start out taping the joint as with any joint. Then, using a 12" knife, spread joint compound vertically to both sides of the joint. Stay about 2" away from the taped joint and bend your knife so the compound (mud) tapers away from the joint. Make sure the mud edge closest to the joint is built up at least slightly about the joint. Let that dry completely. After drying come back with a 4" knife (the one you used to apply the tape) and fill in the resulting middle depression. The idea is to have an ever slight mound about 24" wide or more. If you really want to lose your mind lay a flashlight against the wall and shine the light over your newly "finished" butt joint. If you see a shadow on either side the mud must be built up on the shadow side. Strategic light placement in the finished room helps hide a lot of discrepancies.
There are tons of videos on You Tube that show different methods of hiding butt joints.
Good Luck,
Tim