How do I mud drywall butt joints?
Related Discussions
How do I fix the snapping at the butt joints of my laminated floor?
How do I take off hard water from my tub?
Here’s my issue I have been living in the same apartment building for 18 years and I have a tub that deals with hard water on a daily basis. What is the best way fo... See more
How do I remove paint from painted tile and tub?
How should I remove paint from a tile floor and a bathtub?
What can I use to stop flies from collecting on my new deck?
My deck is new , I was told flies are attracted to the sap of the wood,.
What could be causing a wet floor, if a plumber finds no leaks?
wet floor under sink dry iu and run water no leak? no smell all is clean. run water both tubs, garbage disposal, use sprayer everything underneath stays dry. Go away ... See more
How to hide a pool filter?
Looking to hide this very hideous area. Thinking of a portable coat rack that you use when you have company. Bc it has wheels and can be moved easily.We still have to... See more
Lay a thin layer of mud down the center of the joint. Add your paper or mesh tape over the mud, centered on the joint, then press and drag your mud knife over the tape to set it. Let dry. Use a larger mud knife and apply mud over the tape. Dry. Repeat. Sand.
Karen's answer if correct.
When 'mudding' you will need to apply fiberglass tape to re-enforce the inside wall corner your making. Once taped, you'll then mud over the tape, allow to dry completely, sand, brush off the dust, and then re-mud until smooth and no sign of tape. Paint surface with primer to seal the surface and then use your favorite paint formula.
Dave,
Finishing butt joints are what separates the novice from the pro.
Start out taping the joint as with any joint. Then, using a 12" knife, spread joint compound vertically to both sides of the joint. Stay about 2" away from the taped joint and bend your knife so the compound (mud) tapers away from the joint. Make sure the mud edge closest to the joint is built up at least slightly about the joint. Let that dry completely. After drying come back with a 4" knife (the one you used to apply the tape) and fill in the resulting middle depression. The idea is to have an ever slight mound about 24" wide or more. If you really want to lose your mind lay a flashlight against the wall and shine the light over your newly "finished" butt joint. If you see a shadow on either side the mud must be built up on the shadow side. Strategic light placement in the finished room helps hide a lot of discrepancies.
There are tons of videos on You Tube that show different methods of hiding butt joints.
Good Luck,
Tim