How do I mud drywall butt joints?
Related Discussions
How do I fix the snapping at the butt joints of my laminated floor?
I'm trying to hang a curtain rod over a sliding glass door, but keep hitting something that I can't drill through.
The house is built of cement blocks, but there is drywall on the walls. I had another house that was the same type, but never had a problem with hanging curtain rods.... See more
Can I use my hot glue gun to stick crystals to mirrors?
I have a set of round frameless mirrors and I would like to create a pattern across them with crystals, I'm just not sure which glue is best, thank you.
How can I darken the color of painted furniture using varnish?
Hi, I just paint my outdoor dining set, but the color is a little lighter than what I want. I am planning to apply varnish on them and I was thinking to take advantag... See more
Can a water based varnish be used on chalk paint?
Is it possible to use a water based clear varnish instead of the finishing wax on chalk painted furniture? I love the look of distressed chalk paint but I'd like a sa... See more
Lay a thin layer of mud down the center of the joint. Add your paper or mesh tape over the mud, centered on the joint, then press and drag your mud knife over the tape to set it. Let dry. Use a larger mud knife and apply mud over the tape. Dry. Repeat. Sand.
Karen's answer if correct.
When 'mudding' you will need to apply fiberglass tape to re-enforce the inside wall corner your making. Once taped, you'll then mud over the tape, allow to dry completely, sand, brush off the dust, and then re-mud until smooth and no sign of tape. Paint surface with primer to seal the surface and then use your favorite paint formula.
Dave,
Finishing butt joints are what separates the novice from the pro.
Start out taping the joint as with any joint. Then, using a 12" knife, spread joint compound vertically to both sides of the joint. Stay about 2" away from the taped joint and bend your knife so the compound (mud) tapers away from the joint. Make sure the mud edge closest to the joint is built up at least slightly about the joint. Let that dry completely. After drying come back with a 4" knife (the one you used to apply the tape) and fill in the resulting middle depression. The idea is to have an ever slight mound about 24" wide or more. If you really want to lose your mind lay a flashlight against the wall and shine the light over your newly "finished" butt joint. If you see a shadow on either side the mud must be built up on the shadow side. Strategic light placement in the finished room helps hide a lot of discrepancies.
There are tons of videos on You Tube that show different methods of hiding butt joints.
Good Luck,
Tim