Detail shot
How to repair this very fine Art Deco molding?
I’m pondering a couple of options on repairing this headboard’s tiny wood molding.
It’s “memory” has been in this position a long time & isn’t going to happily go back to its original position with this kind of damage.
TIA.
Overall shot.
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
Water damage on bathroom ceiling
I am about to patch up this water damage on a low bathroom ceiling. What can i paint/seal the entire ceiling with to minimize future water damage? the ceiling is very... See more
Brown paper floor/wall help
I have purchased a brown roll of paper because I wanted a consistent "vein" look through out the walls and the brown paper bags I was getting would sometimes be "vein... See more
I would use wood glue and painters tape to hold in place till the glue dries. Then use some Minwax wood putty to form the molding. Once hard lightly sand to form the molding. Minwax stain marker to touch up the stain color.
You can remove dents from wood with steam. I recently found this video and was amazed at how well it worked. Skip to the 2 minute and 44 second mark of the video. https://youtu.be/SaDirPqvWGc
I eould use wood putty which can be stained to match the finish. Then just sand lightly and press into the dent and smooth the edges so the repair will be invisible.
Hello I would fill the defects with wood stainable wood filler putty and carefully sand the edges to get the proper curves. A potential aid might be an emery board to do the sanding. The emery board is nice and stiff and able to get into the edges and tiny areas.
Thanks everyone. I’m going to use a combination of most of the methods.
A better detail shot of the challenge.
IF you cannot return it to the original position, you could cut or chisel that section out completely. Use a hot glue gun to cover an intact section. Allow it to dry and then use the glue as a mold to recreate a new section that you can glue into the proper position. You can fill the glue mold with bondo, wood putty, etc.