How ia the watering can/ with lights pouring out looking like water,
I've seen the project where they use a watering can and has lights pouring out looking like water. Need instructions
Related Discussions
How do I make shiny galvanized steel look dull like the watering can?
I am planning to use this galvanized bucket to store my hose & the watering can as a planter. Is there something I can do to the shiny upper part of the bucket to ma... See more
Cleaning mineral deposits off of glass
How do I remove mineral deposits from windows??? I've tried cleaning with vinegar on both the inside & outside of the windows...is it possible it's on the inside of t... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
How clean grout from a brick ?
hello all, I just moved to my new APT and I was working on my new kitchen. part of the work is to glue the bricks on the wall 1 centimeter apart so that the grout ... See more
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.
Here's another one for you to look at: https://unskinnyboppy.com/2018/05/diy-fairy-lights-pouring-from-a-watering-can/
Hi Diane, here is a little video that may help
https://www.youtube.com/watch?v=xtO5Kl4b5-4
I actually make and sell these. I use solar fairy lights (the copper wire kind) and metal watering cans with a removable spray nozel. You have to make a few holes in the nozel bitter using a screw driver. I do the one in the middle and four or five evenly spaced a couple of rounds from the center. thread the entire length of lights through the spout starting inside the can. I measure out about 3-3 1/2 feet of lights and fold in half. I do this again for as many strands as I have enlarged holes. Then I fasten them together at the base, where the wire meets the plastic coated wire. Thread each looped section through the holes in the nozel, CAREFULLY, you don't want to break or cut a wire. Push all of the base into the nozel and screw back onto the spout. Hang by the handle. I hang mine on a shepherds hook and attach the solar pad to the hook with zip ties. Make sure the solar pad is on and let charge in the sun during the day. The results are quite pretty. Good luck.