How to splice into an existing backsplash?
We have to add some more backsplash as we are renovating our cupboards. Is it easy to do? We have Casa Roma Glass backsplash that comes in 12" by 12" pieces.
Related Discussions
how easy/hard is it to replace tile countertops with granite and leave backsplash tiles in place?
am hating my white tile/grout countertops - always dirty - but love my blue white checked backsplash - french country look. need an alternative countertop and island... See more
How do you use spacers when installing wavy backsplash tile?
I am going to install 3x6 glass subway tiles for a kitchen backsplash. This style design has uneven, "wavy" edges all around … so how do you use spacers w/this styl... See more
How do I an cover ugly glass mosaic backsplash?
Because we do not have the time nor inclination to rip off the tile from the wall, how do we best cover an ugly glass mosaic tile backsplash in our kitchen? Textured ... See more
Peel & Stick backsplash on an orange peel wall.
I would like to add a backsplash in my kitchen but the current wall has an orange peel surface. Will probably try the peel and stick tiles.
How/where do I end a subway tile backsplash in the kitchen?
So do you normally install the backsplash tile flush with the end of the countertop or flush with the outside edge/end of the upper cabinetry? My countertop is not ve... See more
I need opinions on backsplash!
I hate my kitchen backsplash. I thought I would do a simple white subway tile but it doesn't seem to really match the granite. I don't want anything too trendy. Do yo... See more
What I am understanding is that you have to add to your existing backsplash because you took away a cabinet? Or are you saying that you need a temporary backsplash because you took a cabinet down to renovate it, but you are putting it back up? If you need a permanent solution because you removed a cabinet, I would get tile that complements the existing backsplash very well. Sort of like what you see above a stove. sometimes the backsplash is different in that section but complements the backsplash that goes around underneath the cabinets. If you need a temporary solution to protect a wall while renovations are going on, look at some peel and stick tile backsplashes they have on the market. I hope I understood your question. Good luck!
Installing wall tile isn't difficult. Cement board on the wall first, we screw it in with drywall screws. Using pre-mixed mastik you apply it to the back of the tile then place it on the wall. You will need to figure out the spacing of your existing tile and purchase spacers. Place a spacer on each corner and put the next piece of tile on the wall. Wipe away any excess as you go, including in the grout area or you will have a hard time later.
Make sure to purchase a tile saw or blade to cut the type of tile you have. That is probably the most difficult part of the job.
Once all tile is in place, let it dry. After that you can grout. Once grout is dry, seal.
The best thing to do is cut out some of the tiles in a staggered way so that when you add the new ones it will not be noticeable that you started a new sheet.