Day before Halloween = freak snow storm, no power for over a week.
-
Donna McCrummen on Dec 06, 2011Oops, mistake. The width of the opening is 33" the width of the fridge is 33.5" - we have 1 5/8 to play with - so we need to lose a half inch of the lip. Same question I guess. HmmHelpful Reply
-
-
KMS Woodworks on Dec 06, 2011Is this a laminate counter over a particle board core? If so I would rough out the cut with a circular saw then do some clean up work with a laminate trimmer. The back corner would need to be finessed with a recip saw once the circular saw butts ups at the backsplash. The very back corner could be cleaned up with a RO sander.Helpful Reply
-
-
3po3 on Dec 06, 2011I would pick a new fridge, but that's just me.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 07, 2011This can be done Donna, I would use a router with a guide to assure the cut goes smooth. A plane can work, but the edge can become uneven quite quick. The last few inches where the router cannot reach a good quality fine tooth trim saw can finish that part. Happy Holidays!Helpful Reply
-
-
Bernice H on Dec 07, 2011We had a series of "stuff" happen a few years ago, this brought back those memories! A few thousand dollars later, we finally breathed a sigh of relief. Thank goodness for Dave Ramsey and his advice of having emergency money saved. Hang in there, this too shall pass!Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011@Steve, I would take the easy route but this is the only stainless steel fridge that will even come close to fitting. They are so big these days. Thank you Woodbridge and KMS. I think I get what you're saying :-) just to be clear the opening for the fridge is boxed in vertically not up against a counter.Helpful Reply
-
-
Patricia M on Dec 07, 2011Oops, sorry to hit 'like'....I hope everything works out for you, Donna.Helpful Reply
-
-
Donna McCrummen on Dec 07, 2011LOL thanks Patricia M. I'm sure I can do it - it's just a matter of using the right tools, etc.Helpful Reply
-
Related Discussions
Cleaning mineral deposits off of glass
How do I remove mineral deposits from windows??? I've tried cleaning with vinegar on both the inside & outside of the windows...is it possible it's on the inside of t... See more
What to hang over fireplace?
Right now I have a cream colored berry wreath over my fireplace. I will be getting the picture shown over my sofa ( that is a mock up so size won't be exact). Do you... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
How clean grout from a brick ?
hello all, I just moved to my new APT and I was working on my new kitchen. part of the work is to glue the bricks on the wall 1 centimeter apart so that the grout ... See more
I need a fabric stiffener that is weather resistant. Any ideas?
I created a fabric wreath and have tried two different brands of fabric stiffeners that have failed, any help appreciated.