I have a combination ceiling fan/light fixture in my living room.
-
Dan's of Central Florida, Inc. on Dec 12, 2011You may have/had a short in the wiring, or it is connected wrong. Either way, you should look into it quickly. You can test for shorts if you have a voltmeter. Otherwise you should call in a pro to have it checked out if you don't feel comfortable doing things yourself.Helpful Reply
-
-
3po3 on Dec 12, 2011I always err on the side of pros for electric stuff. I'm willing to try my hand at most other things, but I don't think this is something you want to mess with. Search for an electrician at the top of the page and have them come out to look.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on Dec 12, 2011Depending on the type of fan system you have it may have burned out the remote sensor located in the light housing. I just had the same thing happen to a client of mine. Although her lights come on and off, the ability to dim them stopped working. I looked into the fixture and found that there is a electronic device inside that can be programed to match up with the remote system she uses. Once this electronic device fails it needs to be replaced. The issue with that is, the device costs almost as much as the whole light fixture does new. So were removing the light side of the fixture and installing the light elsewhere in the home where no light is needed and putting in a new fan light combo where this one exists now. But I would also check the switch in the wall. Perhaps a wire came loose and shorted out, or simply the switch may have gone bad. If you do not fee comfortable in checking this out, you need either a handyman or electrical contractor to do this for you.Helpful Reply
-
-
KMS Woodworks on Dec 15, 2011I just did a repair to a clients fan light combo a few days ago. In this case there was no remote , but a light "assembly" that hung below the fan. It was an older unit and in the course of replacing a bulb a massive short occurred. The base assembly of the light housing was pretty fried. The person who was installing the bulbs said flames and smoke were involved, and from the degree of carbon I would agree. To make things safe I removed the entire light assembly and converted the unit to a fan only one. This is located in a rental property and the owner has plans to upgrade at a later date. Next week I am replacing a number of basic light fixture that are also equally "dated"...many have components... better safe than sorry.Helpful Reply
-
-
Midlantic Contracting LLC / Midlantic Electric Inc on Dec 19, 2011Take the fixture off the fan, only three little screws usually, and test for power on the wire feeding the light. If not, it's probably the remote setup. New ones run around $38 at Lowe,s or Home Depot. Only problem is you pretty much have to take the fan apart to install it.Helpful Reply
-
-
ElectraMedics Electrical Services on Dec 19, 2011The remote module has definetly gone bad, if you love the fan, it can be replaced. If you don't love the fan by a new one sometimes there could be something internal in the fan causing it to burn through remotes sensors quickly.Helpful Reply
-
Related Discussions
Best way to make your driveway look like stone with paint?
Several years ago there was a DIY video on how to do this but can't fine it.
Are gray walls here to stay or are they on their way out?
Hey everyone,Gray wall color has long been a favorite choice due to its versatility, modern appeal, and ability to complement a wide range of design styles.But the qu... See more
Which mattress firmness do you prefer: soft or hard?
Finding the perfect mattress can be a game-changer for your sleep quality and overall health.So, we're curious: When it comes to mattress firmness, what’s your pref... See more
Toilet: Rumbling / Vibrating Noise when FILLING up (SMOOTH when flush)
When flushing the toilet, no problem, smooth flush like all others, no issues. (My 1st inclination of the noise when filling up was a clogged toilet, but it flushes q... See more
Clean grout hard (iron) water stains?
We have a shower that has laminate side and flooring. The areas were grout is has turned orange/Black. I have used vinegar applied with toothbrush, Granite Gold grout... See more
How do I remove super glue from a rubber floor mat?
I spilled glue on my rubber floor mat and have tried alcohol, soap, goop and some other things, but nothing took it all away.
How to remove cigarette smoke smell from my sewing machine?
I just bought a used sewing machine. Brought it home and wiped it down with Clorox wipes and they were dirty. Now the machine reaks of cigarette smoke. I tried vinega... See more