Dust collection on Compound miter saw
-
3po3 on May 01, 2012I think ShopVac makes dust bags for these situations. I know people use them for drywall dust but it could work for your situation.Helpful Reply
-
-
KMS Woodworks on May 02, 2012I second Steve comment...I have 8 and 5 gal "shop vac" brand shop vac and use the disposable "bags" the foam and or pleated filters do not collect as much fine material. prior to using it is important to clean the motor assembly I use my air compressor and nozzle to remove any "dust" from the inside and out of base as well as the motor assembly. My miter saw in my shop in not hooked up to my dust collection systems. It just hits the wall behind it. now and then I just suck up the sawdust. I really only use my collectors for my planer, jointer and table saw.Helpful Reply
-
-
Woodbridge Environmental Tiptophouse.com on May 02, 2012You must be carefull when using a vacuum to catch this fine dust. This can cause an exposion if not properly handled. Dust bags designed to be used with shop vaccums are the best way to keep this stuff under control. Combined with a high end pleated filter you should be fine. Another way to keep this under control is to install a small dryer vent hood on an outside wall and pipe the discharge end of the shop vac out that opening when its in use. The fine dust will be expelled to the outside of the room. But remember as KMS said, you need to clean the vacuum as dust will collect on the fins of the blower and on the motor as well. The last method costs a bit more, but its well worth it if you do a lot of wood working. A cyclonic vacuum designed to collect dust is exactly what you want. They do not cost as much as you would think, and can be installed outside with just a hose system running in the shop so you do not have to hear them run while you cut wood. Here is a link for one that is not that expensive and works pretty well. http://www.harborfreight.com/2-hp-industrial-5-micron-dust-collector-97869.htmlHelpful Reply
-
-
Douglas C on May 14, 2012You must watch out for static electricity.....when you vacuum dust it creates static and that is what will get you in trouble. Google for ways to stop this.Helpful Reply
-
-
KMS Woodworks on May 15, 2012I have my main 2500 cfm dust collector plumbed directly outside. I will sometimes move the hose about when it is running. The static is REAL as I have been shocked a few times...a bit like running wooly socks over the carpet and touching a metal door knob.Helpful Reply
-
Related Discussions
How do I repair a small rip in my leather couch seat ?
Bummed out! One of the kids put their foot with a shoe on it, on the couch and created this tear in the seat cushion. I’m wondering if I can sew it, instead of pay ... See more
How do I remove shattered glass from a picture frame?
How do I remove scratches from a silver frame?
I have some scratches on my silver frame. Is there a way to remove them or make them not as noticeable?
How do you remove scratches on flatware?
The flatware that I use everyday have a lot of scratches, especially on the tines of the forks. Is there any way to remove or reduce these scratches other than buyin... See more
How to remove paint from hinges
how to remove paint from hinges on cabinets doors still attached . want to paint kitchen but so much painted over hinges , screws won't budge.will i need to cut aroun... See more