what are some tips for first-timer installing laminate floor?
-
Imagery on Mar 18, 2011Felicia, the best tip I can give is, to make sure you you leave enough room for expansion and contraction, I have seen many floors turn into big messes when the wood expands, leaving a large bump in the middle of the room.Helpful Reply
-
-
KPT Carpentry on Mar 19, 2011Hi Felicia, make sure you vacuum up the subfloor real good before you put down your new floor.Helpful Reply
-
-
3po3 on Mar 19, 2011Have fun. Installing laminate flooring is a fun DIY project. Plan. It may sound stupid, but I have seen projects where people just started laying flooring in a bedroom only to realize later that they really wanted the flooring to run the other direction in their main living room. The basic rule of thumb is that you want the boards to run perpendicular to the closed front door. IE, when you walk in the front door, you are looking down long planks, not at a "stairway" of sideways planks.Helpful Reply
-
-
Chae on Mar 19, 2011Depending on size of the room, consider installing from the middle. Generally you start from the longest wall and move across the width of the room (keeping in mind the existing, if any, orientation of wood floors), but if the room is not perfectly rectangular, you could end up with awkward gap once you reach the opposing wall. Consider that if the room is only 2-3 inches out of square, you may have to rip the planks at an angle and still end up with visible flaws. By starting from center, you share the flaws both sides, so 2-3 inches out of square becomes 1-1.5 inches out of square each side and easily covered up with shoe moulding.Helpful Reply
-
-
Carl Peters Jr. on Mar 19, 2011Beyond following the directions printed on the cartons containing the flooring, there are a few things that make the job run smoother. Cut down some scrap pine to 3/8 of and inch and duct tape small pieces to the wall before you put your first course down. Maintaining gaps around the perimeter, as well as all doors heat pipes is key when laying these floors. Stagger seams as directed but ensure that you are getting maximum coverage from each piece. Lay out a few rows to see if you like the look and placement of panels. Use the more expensive underlayment--a few dollars more but you'll notice the difference. Remove base moulding and any remaining tackless nails from the subfloor and clean the area well. Dryfit two pieces together to get the feel of how they snap together and to see what a locked seam looks like. Lastly, wear kneepads, it makes the job alot less painfull.Helpful Reply
-
-
KMS Woodworks on Mar 19, 2011Laminates are hard on saw blades...as your project progresses you will notice a performance drop is cutting. Also be vary careful handling the planks the corners are very vulnerable to damage and can not be repaired once install short of replacing the whole plank, which if in the middle of the room can be a pain.Helpful Reply
-
Related Discussions
How to remove Behr Deckover?
We used Bher Deck over about 5 years ago. It is peeling and fading in places. We have tried to remove it. It is almost impossible. HELP!
What are your thoughts on painted brick: yay or nay?
Painting bricks can completely transform the appearance of a home, giving it a fresh, modern look or adding a pop of color to an otherwise plain facade.On the other h... See more
Getting rid of burdock-Anyone know a non toxic way to get rid of them?
i am clearing an area to plant a butterfly/bee wild flower garden. The area is full of burdock and the soil is hard packed clay. I have been digging the burdock out... See more
The shelf life of Chalk paint?
I have a jar of Ann Sloan chalk paint I bought several years ago. It has never been opened but it has separated. As it was very expensive and I have a project in mi... See more
Should I paint or stain my oak kitchen cabinets?
I was wondering if you could help me with something -- I have an entirely oak kitchen. I know it's the rage now to paint or gel stain cabinets. I've been considering ... See more
Help please! What color for the front door?
We're remodeling this 1930's house. We have a new red metal roof & plan to keep the white siding. What would you suggest as a front door color? I love bright, bold co... See more