Refinishing a fire pit
Related Discussions
GNATS - How to get rid of them?
Somehow my house and garden got tiny gnats that killed my fuchsia plant and fly everywhere. I have tried ALL the Web recommendations - soap and oil dishes, sand in th... See more
Marigolds growing! Should I pinch the buds?
My marigold plants are growing. I heard that pinching the buds until Autumn will allow them to grow without killing the plant. Is this true?
Growing garlic
Growing our first garlic, should we wait until the leaves are drying out before we pick it? Husband picked first one today along with our first potatoes.
How to keep mice out of your garden?
Hi everyone, I have mice in my garden destroying my vegetables and I have also noticed them in the barn and shed. Please can someone tell me how to prevent them from ... See more
What's the best flower/plant to grow in Texas?
I know that opinions vary, but what's your opinion?!I have great luck w Rosemary plants. Green all year long.
Heat from Fire pit-How close to vinyl siding can a fire pit be placed?
How close to vinyl siding can a fire pit be placed. Do not want to damage the siding.
Is it necessary to line a fire pit with fire brick?
I built a fire pit with cement block but the mortar joints have cracked after only a few small fires. Should I start over and use a fire brick liner?
I have had the same problem with the paint on my fire table peeling. Have you found anything that works yet? I have not had any success.
Believe it or not, I'm just getting around to working on this project. When looking for the high temp mortar, there is the consideration that it is an outdoor firepit, and will have rain exposure. Would that change your recommendation? Any better product to use? Will the thickness of the tile make a difference? Thanks for your help. Kim
We have the Real Flame rectangular fire table, and the fibreglass has cracked and chipped worse every year due to the Canadian climate. Our first attempt to mask the damage was to use 3 stain colours to do a faux marbling of the table, which looked awesome for one summer (then the table chipped and cracked further during the winter [stored inside the garage]). Last year, we fiberglassed the areas with missing chunks and the larger cracks. Pulled it out this spring to see that those have also peeled and lifted. Our next attempt will be to build a cedar cover for it that can lift on/off. We’re thinking of using the thin cedar slays that you see on houses, leaving small gaps between slats, and then we can just vacuum off the new chips each year, but at least it’ll be nice to look at. Note that our table has glass panels that will act as a barrier between the fire and the wood.
I have a similar problem with my "fiber reinforced concrete" gas firepit.
It was suggested to me that I clean all of the cracked bits off, then seal the entire top with EPOXY RESIN, then sand & paint it with high heat paint (engine paint or furnace paint). From my little bit of researching, epoxy resin seems to be heat resistant & fire proof. Any thoughts?
Lowe's carries a high temp gray motar.
https://www.lowes.com/pd/Sakrete-50-lb-Gray-Type-High-Heat-Mortar-Mix/1000250707