Peeling paint on laminate
I had my laminate den panelling painted. My painter supposedly primed it and then painted. I suspect that what he did was simply apply a coat of "paint with primer". Shame on me for not keeping tabs on this. Anyway, now the paint chips off wherever it is nicked in the slightest. Is there any way to deal with this other than sanding off all of the paint and redoing it correctly? I'm getting ready to sell my house want to minimize the headaches and expense but I want to spruce up the look of these walls.
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
What can we do about laminate peeling near the oven heat?
peeling near oven heat. Hate color
Paint peeling fix on a budget, what would you do?
This 1938 old gal is showing quite a lot of wear. The walls & ceiling in the kitchen are bubbling & peeling. Likely there is lead paint. Hub said no water damage but... See more
Now that your painter has painted it I believe you can simple paint over it again. The first coat of paint should act as a primer. Perhaps you can touch up the nicks first--either with paint or some spackling and sand lightly if you need to.
Sand as much off as possible and prime it again before painting.
The "paint and primer" are really not primers. They just have more paint solids in them. Do what Cindy suggests and use a primer like Kilz then paint. Kilz should seal what the painted did.
Sand where there are chips. I would at least use a high-adhesion primer where the chips are and paint over those. I have panelling and wouldn't use 2-in-1 paint over it. Even over drywall it can chip. However as GA said, maybe that would be a base coat now.
I found that 2-in-1 paint needs 3 coats to stay stable on my drywall, with a longer drying time in between coats. It looks good in less, but doesn't hold up.
I personally like Zinsser BIN 123 shellac-based primer. It holds up well and provides a good tooth for paint. My panelling has only chipped in a couple of spots in 20 years, and that was from very hard hits that would have dented drywall.
Perhaps the laminate was not washed before painting. Paint better adheres to washed surfaces.