How hard is really to install bathroom faucets ? scale 1-10
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
Tiling a bathroom wall, and installing a mirror and light fixture
I plan to tile my sink area from vanity to ceiling with tiles. If I am installing towel bar, keeping switch plates and want to update light fixture and mirror should ... See more
How can I update old 1X1 inch bathroom floor tiles?
I hav very old tiny ceramic tiles. I want to update them without having to do the hard work of removing them. A stencil sounds great but every time I see it it’s on... See more
I would say maybe a 6. The only reason I rate it so hard is because you’ll be working inside the cabinet, on your back. It is usually difficult to access the threaded rings that hold the faucet down, you must seal the new faucet, and make sure you don’t have any leaks. If there are no shutoff valves you will also need to turn the water off before starting, and turn it back on after the repair.
If you have never ever installed one, expect it to be a 10. Your first one is always the hardest. After that, each successive faucet gets easier. Grab a friend and do it together and follow the instructions. You CAN do this, just be patient and do not try to rush the process.
Pat...honestly, there are more variations to know to give an answer. We took out an old faucet set and thought it would be a snap. It was a snap to install, but when we tried to plug the drain, the stem of the drain was angled and hit the wall so we couldn't close it. Other's might be fairly easy. The age of your sink and replacements available could vary by 1/4" and not work. If you're determined and have to get rid of the old, take it down with you to buy a new one. Measure everything for spacing and depth. Best of luck! I hope someone else has had better luck than we have.
Old plumbing is rarely easy, some little part will give you fits. It is a doable project, as everyone else said, you have to have patience.