How do I cut a piece of white Styrofoam without leaving a jagged edge?
I am looking to cut a one inch thick piece of packing Styrofoam into smaller pieces for a project I have in mind. No matter how sharp the knife is, I keep getting jagged edges at the cut. Any suggestions?
Related Discussions
Chair rail height?? At the sill or below or around?
I am running chair rail around a bedroom. The marble sill is 40" from the floor the window is 39" high. Putting printable wallpaper on the bottom. Painting the botto... See more
Best nail gun?
I am very new to working with tools and am wondering what the best type of nail gun I should buy to work with pallets. I am interested in redoing a wall with pallets ... See more
How can I seal old chipped wood?
I have a few amazing pieces that are old and the paint is chipping. I love them just the way they are but hate the flakes that constantly come off! What to do so it'... See more
How to make a magnetic picture board to display (travel) magnets.
Cutting a wooden spool
Can anyone suggest the best way to cut a wooden spool in half length wise. Approx. 16 "tall, ends are wood and the center is thick. I have several different power saw... See more
Use the sharpest knife you can find. I have one very expensive knife and that's the one that I use for cutting Styrofoam, but it's still not perfect. I still have to pull small pieces off with my fingers and try to get it as flat as possible that way.
piano wire may work for a smooth cut .
If you need to cut styrofoam frequently, lots of folks favor hot wire cutting tools. There are some diy plans out there, but they aren't that expensive either:
https://www.amazon.com/gp/aw/d/B07FKCR47W/ref=sspa_mw_detail_1?ie=UTF8&psc=1
Work in a well ventilated area- fumes!
Jamie,
I have heard some people use an electric carving knife, but I have never tried that method. I have used a serrated bread knife before, but found a coping saw, which has a very thin blade with very fine teeth, makes a clean cut. You try using a box cutter with a long blade and heat the blade with a torch (saw this one on YouTube) so it will melt through the foam.