How to prevent frozen pipes?
My daughter and son in law have a basement and a 1st 2nd and 3rd floor house. It was an old house that was renovated. Apparently the water pipes run up along one side of the house but were not insulated sufficiently so the 2nd and red floor pipes freeze in the harsh winters (Northeast). Any suggestions what they could do besides ripping the wall off to get to the pipes and insulating them better.
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
Hot Water Pipes Frozen!
My hot water pipes froze 3 nights ago. We still have cold water but when you turn the hot tap on, no water comes out. It just makes gurgling noise. This goes for all ... See more
I have ruined my copper sink! Please help!
I'm hoping to save my copper sink, but I am afraid I have totally ruined it. I need some suggestions on how to save it! What can I spray it with, or where can I fin... See more
How long ago did they buy the house? What did the inspection report reveal, if anything?
That's about all you can do. But it will be worth it.
Hi, Chris,
If you live in the Northeast, you'll recognize that If their house was renovated (as in changing out plaster to drywall), they'll most likely have to rip down the drywall and add insulation. Keep in mind that given the probability of stick construction of that time, deeper insulation to meet today's recommendations will not be possible.
Hopefully, the house is not "brick on tile" construction, which tended to have no insulation, as coal heat was cheap. Even if their home had been built in the 1950's, homes generally had little more than a minimal layer of rockwool, because the prevailing attitude was "gas forced air heat is cheap".
As illogical as it sounds, it was not unusual for plumbing pipes in kitchens, bath and basement laundry areas to have pipes located on the outside wall, even when some sections of the foundation were below ground level. It was typical to have to leave faucets at a trickle during cold weather, and utilize a bathroom wall mounted heater.
Hopefully, the attic floor was well insulated during renovations, and all air leaks were sealed in that space.
Thank you for your response. I will tell them to get the attic checked to see if there are any leaks. I dont know if in their area energy inspections are done, but maybe with an expert to look into it maybe they would get to the root cause and have it fixed.
They don't need to tear the walls out totally. If they can locate where the pipes are all they need is to cut the drywall by the pipes. Use foam pipe insulation or wrap them with fiberglass pipe insulation. Then just patch what was cut out. There many new products that can see through walls. Walabot is one. Technology is great.
https://www.youtube.com/watch?v=8vlETBstd38
Thank you. This is helpful. Will pass this info on to them.
I think running water works better than anything. I turn on faucets to a low drip and so water is running through the pipes all the time.
Used to do this...but most people in this world pay to have what we would consider brown water delivered, and never have enough.
Exist efficiently...