What kind of drill bits are used to drill holes in ceramic and glass?
![Geo.](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-G-1ABB71.png?size=91x91)
![](https://cdn-fastly.hometalk.com/media/profile/2021/08/22/193692_1.jpg?size=50x50)
![](https://cdn-fastly.hometalk.com/media/profile/2014/10/03/1147758.jpg?size=50x50)
![](https://cdn-fastly.hometalk.com/media/profile/2014/12/27/1889949.jpg?size=50x50)
Related Discussions
Why is it important to wear a mask when sanding?
![Liz](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-L-FF8282.png?size=50x50)
You said you had a bad experience from sanding without a mask. Could you give me any info in that so I can encourage my brother to use one
Has anyone been able to locate "Wood U Bend Moulding" in the US?
![Pg](https://cdn-fastly.hometalk.com/media/profile/2015/05/18/1696666_2.jpg?size=50x50)
There is a molding being sold in England, at least, called Wood U Bend. It can be heated to allow bending. I have not yet found a source from which to get it in the U... See more
What kind of saw did you use to cut the dresser in half?
![Kim](https://cdn-fastly.hometalk.com/media/profile/2017/06/15/1578774_1.jpg?size=50x50)
How do I make a template to drill holes for cabinet hardware?
![Leslie Espinosa](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-L-FF8282.png?size=50x50)
We had cabinets installed without hardware. Now we want handles and knobs but will need to put them on ourselves.
Caulk gun? what am I doing wrong?
![1cs1267](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-C-F1C40F.png?size=50x50)
I'm a senior, attempting to use caulk gun for the first time. Have my "cannister" of caulk, cut the top off ... nothing will happen. Takes all my strength to "pump"... See more
What are the best screws for use on corrugated metal?
![1cs1267](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-C-F1C40F.png?size=50x50)
I am putting up a backsplash using a sheet of new corrugated metal. What is the best type of screw to use for attaching this to the studs on the wall? I need somethin... See more
You will need a carbide-tipped bit for your project.
I got mine at Harbor Freight. It was the cheapest there.
I just made a lamp out of a bottle and used a $5 for 5 diamond tip bit. Cut the hole in seconds but I did need to make a template. You can see how on this post https://uniquecreationsbyanita.com/diy-game-of-thrones-lamp/#more-6294
be sure to use water also, or it will get to hot. Be very careful if it’s electric. Check out Utube,on how to do it correctly.
Diamond bits are the easiest to use but they require water to cool the bit and to keep from breaking the glass. It's helpful to drill the hole while water is trickling on the bit from the faucet or the piece can be drilled in a plastic tub filled with water. Hope this helps!