Can I cut a piece of a load bearing wall to open up my space a little?
I have a load bearing wall separating kitchen and living room. Is it safe to cut a large piece out of wall to open up space a little more?
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
How do I fix wallpaper that's peeling off?
The wallpaper on the corner of a wall in my house is starting to peel off. Any advice about the best way to glue it back?
How to seal the seams of vinyl wallpaper?
We are renovating our guest bathroom. We put up vinyl wallpaper along the tub/shower wall. I am not worried about the wallpaper itself getting wet because it is viny... See more
Sue...Yes you can do that as long as you beef up the load bearing areas (such as adding a window). Good luck!
For anything load bearing it is best (and often required by codes) to consult and engineer. I am all for saving money by doing stuff myself, but when it comes to load bearing, you can really mess up your house if you don't know what you're doing - especially if you have a two story house. Plus, it could fail inspection when you go to sell it.
Chances are good that you would need to install a pretty significant beam across the open stretch, but I don't begin to know what the building codes in your area require in terms of support posts, footers under the support posts, size of the beam needed, etc.
You still might well be able to do it yourself, but you need the advice of a professional who is familiar with building codes in your area.
When my son was remodeling his house he actually found the kitchen wall that had a 5' x 5' square cut out of it, an opening where the kitchen looked into the dining room, had been there on a load bearing wall since the 1950's with no problems. He only had to reinforce it when he was taking out that wall completely. You should be fine :)
I agree about building codes, etc. But, if you are only removing the sheetrock between the supports I don't know how it would interfere with the actual supports. But, I'm not an engineer so speak with your local building code and inspector to ask this safety issue.
Thank you for all the insights !