How can I make a live edge board out of a straight board?
![Mike](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-M-605BE8.png?size=91x91)
Related Discussions
How do can I best cut a hole to make a shelf in a Ikea Malm headboard?
![Mer13641644](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-M-59A1F4.png?size=50x50)
Ikea Hack: I want to make cubbie holes with shelves behind the headboard for storage (cell phone, tissue, book, etc). Given that the headboard is hollow what tools do... See more
Why is it important to wear a mask when sanding?
![Liz](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-L-FF8282.png?size=50x50)
You said you had a bad experience from sanding without a mask. Could you give me any info in that so I can encourage my brother to use one
Has anyone been able to locate "Wood U Bend Moulding" in the US?
![Pg](https://cdn-fastly.hometalk.com/media/profile/2015/05/18/1696666_2.jpg?size=50x50)
There is a molding being sold in England, at least, called Wood U Bend. It can be heated to allow bending. I have not yet found a source from which to get it in the U... See more
What kind of saw did you use to cut the dresser in half?
![Kim](https://cdn-fastly.hometalk.com/media/profile/2017/06/15/1578774_1.jpg?size=50x50)
How do I make a template to drill holes for cabinet hardware?
![Leslie Espinosa](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-L-FF8282.png?size=50x50)
We had cabinets installed without hardware. Now we want handles and knobs but will need to put them on ourselves.
Caulk gun? what am I doing wrong?
![1cs1267](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-C-F1C40F.png?size=50x50)
I'm a senior, attempting to use caulk gun for the first time. Have my "cannister" of caulk, cut the top off ... nothing will happen. Takes all my strength to "pump"... See more
Hi Mike. If you're keeping the board with a straight edge, you can find yourself a downed tree or sapling. Remove the bark with a draw knife, then use exterior rated wood glue to attach it to your board. When dry, trim to fit the board's edge. Stain and seal. If you're cutting a shaped edge, you can use the same method to retrieve the bark, but will need to soak it in hot water to make it pliable. Attach to your edge with tape and/or shrink wrap. Let dry in a sunny location for a few days. Remove your wrap/tape, glue the bark on and trim up the overhang. Stain and seal.😊
It's really it's own thing. The beauty of a live edge is it's not straight.
Cut a raggedy edge and sand it well. Start with a heavy grit sandpaper like 80, then sand with 120, then sand with 220. This will get the edges nice and smooth like live edge appears after you remove the bark.