Front & back views of failed screws.
How can I repair this cedar and steel privacy fence?
The cedar & steel frame privacy fence is showing its’ age & four reamer-type self-tapping screws have fallen out and their cedar boards with them. The only thing I can think of is fill the threads with exterior grade Liquid Nails and the back of the boards and the steel frame as well. What do you think?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
What can I do about the sharp edges on my privacy fence?
Suggestions please. I have a privacy fence around my back patio so I can enjoy my hot tub with out the neighbors seeing. The fence panels are 2 feet off the groun... See more
Hi , I would go grab some more hanger (metal ones for 2x4) and some new 2x4, cut it to fill the gap and and nail the cedar boards on to it. that will keep you going till it can be replaced
More pictures would really help!
Can't tell by the photo. If you didn't use screws with wings to ream out the hole in the wood without catching the tread then it wouldn't properly fasten to the metal. The wings allow for no predrilling the wood. Also some wood to metal screws have nibs in the head to create a countersink. This tightens the wood to the metal so the screws don't loosen and fail. Construction adhesive may help but the holding power is in the screw. It's possible the screw treads were dulled by the wood just enough and limited the gripping to the metal.
https://www.homedepot.com/p/Teks-12-2-3-4-in-Phillips-Flat-Head-Self-Drilling-Screws-40-Pack-21384/100145370
https://www.strongtie.com/screwsandnails_fasteningsystems/category?v=%3Arelevance%3AfeatureApplicationMenuFacet%3AFastening+Wood-to-Steel
Can you put new tek screws through the boards and frame in a different place than where they were originally? If so, I'd do that and be sure you do NOT drill pilot holes or they won't work as designed.
My next thought would be to move up to a larger size tek screw in the same holes but they may not work as they should unless you move up in size significantly.
Otherwise, short of purchasing new wood you'll have to fill the holes with something. I'd think perhaps epoxy or other really hard substance once dry.
https://www.youtube.com/watch?v=9fcHw8mMk8c&app=desktop
https://www.allpointsfasteners.com/blog/how-to-use-tek-screws
Did the screw itself fail or did the hole that in the steel structure start to rust?
Thanks, everyone, I’m going to get a box of larger tek screws.
The surface rust is minimal.
All can think is that their pilot holes were too big.
I did try putting the still-useful old screw into a new place in the steel rail. It would even bite without a new pilot hole and I’m not interested in crouching in 30 degree weather to do the lower screw holes all over again.