How do you clean those yucky whirlpool tub jets?

by Sdb28059748

Does anyone have tips on how to clean bathtub jets?

  6 answers
  • Amanda Amanda on Aug 03, 2017

    I fill the tube up with hot water and add dishwasher power detergent and run them for about 10-15 minutes. It is amazing how much crud comes out.

  • B. Enne B. Enne on Aug 03, 2017

    Fill tub with hotwater above jet line, add dishwasher pucks and let sit for 10 minutes (if necessary), then run jets for 10 minutes.

    Once that is done, I just flush out the jets after every bath by removing my hand held shower head, and putting the hose in the screw off jets at the top, it runs the water through the lines.

  • Squirt them with rubbing alcohol. Use an old toothbrush to get into the nooks and crannies.

  • Jane  Rapisarda Jane Rapisarda on Aug 03, 2017

    dishwasher detergent into a tub of hot water ,let it sit for ten minutes , run the jets for another ten minutes ,drain the tub and then rinse it out

  • Cindy Darsey Chadwell Cindy Darsey Chadwell on Aug 03, 2017

    I run a hot bath and add a cup or two vinegar. Turn on jets (high) and run for 15-20 minutes. Then I a cup of powdered dishwasher soap and run for another 20. Drain. Refill and run with clean water for a few minutes.

  • Sunny C Sunny C on Aug 03, 2017

    Hello Sd; I scrub mine with an old toothbrush. I use hydrogen peroxide and dawn soap

    I hope that this helps you!!! Take Care!