I'd like inexpensive fixed-louver french doors between master bedroom & bathroom but opening is 34"w x 92"h. Ideas?
-
Designs by BSB on Apr 20, 201234" would equate to really small doors. Do you have wall room to one side of the opening? You could do a single door and have it sliding. See picture below. While this shows a mirrored door, take notice of the sliding mechanism at the top. Im not sure where you would go in your area to get the door. It would be best to get one slightly larger in width and height to cover the opening all together.Helpful Reply
-
-
Jeri on Apr 20, 2012Thanks BeckySue. There is not enough room for a sliding door on either side of the opening. About 16" on the right it angles out about 120 degrees and does a similar thing about 20" on the left so I had to rule out the sliding (and pocket) door ideas.Helpful Reply
-
-
Designs by BSB on Apr 20, 2012ahh too bad. Tough decision ahead of you.. but Id like to encourage you to think it through. More often than not, folks find small french doors like that a PIA. I will be removing a pair in a near future remodel, their major complaint was that the catching/locking mechanism to keep them closed is nosey and annoying to push/pull. On the other side, I find most dislike have the little doors .. time consuming to open/close.Helpful Reply
-
-
Jeri on Apr 20, 2012Thanks for the answers, but I'm still hoping for more ideas.Helpful Reply
-
-
AK Complete Home Renovations on Apr 20, 2012Jeri, Thanks for reaching out. i agree with Becky that this is a small opening for fixed doors. In any event take a look at this website where they have a standard offering of 30" x 80". http://www.doors4home.com/p-254-louver-door.aspx?gclid=CJP685C8xK8CFZNV7Aod2jysXg& This may work for you. There is always the option to have a custom made door for you which will probably double the cost of the material plus your labor , drywall, painting, etc. Good luck with the project and post the finished pictures so we can see the end result.Helpful Reply
-
-
Jeri on Apr 21, 2012Thanks for the answers, but I'm still hoping for more ideas. :D I probably won't be doing this until June so I've got a bit of time to keep on searching.Helpful Reply
-
-
KMS Woodworks on Apr 21, 2012The link AK posted has 15" by 96" that could be cut down and used as a "pair" in a french double type configuration...but building and installing a custom "jamb" assembly to hand this pair may put your cost up above a truly custom "pre-hung". Most "paint" grade louver doors are pine, the so the cost of the Mahogany above may not be needed. Framing the opening down to take a stand 80" high door may help too.Helpful Reply
-
-
Jeri on Apr 25, 2012I've decided to hold off until the new bathtub, counter and fixtures are installed. At present I am considering the idea of "Framing the opening down" or using curtains (again) only this time with a valance. I plan to post a picture once it's done. Thank you all for your suggestions!Helpful Reply
-
Related Discussions
How do I repair a small rip in my leather couch seat ?
Bummed out! One of the kids put their foot with a shoe on it, on the couch and created this tear in the seat cushion. I’m wondering if I can sew it, instead of pay ... See more
How do I remove shattered glass from a picture frame?
How do I remove scratches from a silver frame?
I have some scratches on my silver frame. Is there a way to remove them or make them not as noticeable?
How do you remove scratches on flatware?
The flatware that I use everyday have a lot of scratches, especially on the tines of the forks. Is there any way to remove or reduce these scratches other than buyin... See more
How to remove paint from hinges
how to remove paint from hinges on cabinets doors still attached . want to paint kitchen but so much painted over hinges , screws won't budge.will i need to cut aroun... See more