why does the new washer smell like mold or old staning water
I have a white porcelain kitchen sink and the caulk has turned brown, I guess over 18yrs, the age of my house. It looks awful. How to remove old and replace new caulk... See more
Hi,I have a Whirlpool stacked Thin Twin LTE6234DQ2 dishwasher with direct drive, which is malfunctioning lately.I have been using a Whirlpool Do-It-Yourself Repair Ma... See more
Cooking a casserole I put Aluminum foil on the bottom of the oven. It stuck to the bottom and I can;t get it up with out damage to the oven. Like it was glued down? w... See more
How do I stop my pillow from floating to the top in my top loader?
My mother in law has a silicone liner in her microwave as a “noise” buffer and an easy cleaning. So I’m curious as to, if one can use a vinyl shelf liner for t... See more
If I buy copper paint will it look like copper on an old stove fan?
My kitchen is the original for this house. Built in 1960's & has a corner round dishwasher that still spins & water comes out, but I cannot get it to hold the soap. ... See more
Is there a glue/plug/simple way to make it safe and secure again?
It’s right under the top and I don’t know what would make it smell?
I've changed to Tide laundry detergent, used baking powder and ammonia nothing seems to work. I do not overload and clothes are immediately placed in dryer after wash... See more
Any advice to help me fix a plastic crack in my hose wand. I used a heat gun it didn't work. It's in a spot hard to get to but read about model glue but don't know wh... See more
how often am I suppost to give my ac a tune up just got a bill for $490.00 // I do have a pool but that to much
I have an old refrigerator that I've cleaned well and covered with vinyl wallpaper but left 2" all around for wood trim. I need to know what glue would adhere the tri... See more
It looks like something was sprayed on it (which was not the case) and I can't seem to get it to look clean. Thanks!
the door had small rust spots on it and always looks dirty.
Washing machine dispensing fabric softener around the top of the drum not in the drum. Any suggestions?