How ia the watering can/ with lights pouring out looking like water,
I've seen the project where they use a watering can and has lights pouring out looking like water. Need instructions
Related Discussions
How do I make shiny galvanized steel look dull like the watering can?
I am planning to use this galvanized bucket to store my hose & the watering can as a planter. Is there something I can do to the shiny upper part of the bucket to ma... See more
What to do with the top of this piece of furniture?
I am planning on using the bottom as a credenza in my dining room any suggestions what I can do with the top?
Getting rid of wild day lilies
Our yard is covered with wild (I assume, since we never planted them)day lilies which have taken over our yard. Short of blasting them with Roundup, is there anything... See more
How to change a Zipper colour?
I have a lovely pair of black boots with silver zippers. I would like to change the colour of the zippers, 2 on each boot, to black without screwing up the zippers...... See more
Review: Command Hooks Are Life Savers! What Do You Use Them For?
I LOVE these little life savers. I'm a renter so I always have to find that balance between making my space mine and making my landlady angry.That's why I'm crazy abo... See more
Is washi tape recyclable?
I'm moving to a new place and taking down my renter-friendly washi tape decor when I thought... wait, isn't this just paper? Can I chuck the washi paper in the recycl... See more
Here's another one for you to look at: https://unskinnyboppy.com/2018/05/diy-fairy-lights-pouring-from-a-watering-can/
Hi Diane, here is a little video that may help
https://www.youtube.com/watch?v=xtO5Kl4b5-4
I actually make and sell these. I use solar fairy lights (the copper wire kind) and metal watering cans with a removable spray nozel. You have to make a few holes in the nozel bitter using a screw driver. I do the one in the middle and four or five evenly spaced a couple of rounds from the center. thread the entire length of lights through the spout starting inside the can. I measure out about 3-3 1/2 feet of lights and fold in half. I do this again for as many strands as I have enlarged holes. Then I fasten them together at the base, where the wire meets the plastic coated wire. Thread each looped section through the holes in the nozel, CAREFULLY, you don't want to break or cut a wire. Push all of the base into the nozel and screw back onto the spout. Hang by the handle. I hang mine on a shepherds hook and attach the solar pad to the hook with zip ties. Make sure the solar pad is on and let charge in the sun during the day. The results are quite pretty. Good luck.