How do I make a clothing rack out of wood board for my basement?
Related Discussions
Can I ask Home Depot to cut my wood?
I'm seriously considering making this twisty side table that I fell in love with here on Hometalk (By Chasing A Dream), but cutting the wood is a bit too ambitious fo... See more
What to do with our livingroom ceiling?
We took the old popcorn ceiling off in our livingroom and thought we could just paint it. We fixed some hairline cracks where the joint in the sheetrock are, primed a... See more
What type of hinges are used on the top of this folding table?
Does anyone know what type of hinges are attached to the top of this folding table? The legs fold in toward the back then the top folds down flat against the legs.
How would I be put on these wheels ?
I am planning on doing a mobile wood bench using 2x4. I have these wheels but have no clue to put them on
Sealing/smoothing crate wood
I am turning the sides of an old wooden crate into a coffee table top. The wood is similar to pallet wood: unfinished and prone to giving splinters. How might I go ab... See more
How do I make DIY furniture sliders to move heavy furniture?
HOW DO I MAKE FURNITURE SLIDERS TO MOVE HEAVY FURNITURE.Best furniture sliders!Move furniture easily with Round furniture moving kit that Amazon reviewers swear by!
https://www.youtube.com/watch?v=Oi_9RDicN70 or just add a bunch of hooks on the board and hang the board on wall use molly bolts to hold weight here are lots of videos https://www.youtube.com/results?search_query=diy+coat+rack
There are two basic construction styles as shown in the photo below. Note that the wood dowel rod that holds clothing should not be longer than 4 feet to prevent sagging. For longer lengths you should provide another support post to the middle of the rack. Basements tend to be damp and could be subject to flooding. Make sure that the completed rack will hold the bottom of clothing at least 1 ft above the floor. Plan on using plastic containers to protect your clothing both from dampness and insects.
The rack on the left has a mortise and tenon joint holding the posts to the base. A simpler method would be to use long (5") screws. The rod at the top slides through holes drilled in the posts. You will need a circular saw or crosscut hand saw, and a drill. The rack on the right is simpler in that it only requires holes drilled in the posts for the dowel rod, with straps, cable or chain to limit spreading of the uprights. You would still need a saw and a drill.
Here is my shelves I made for my closet https://www.prettyhandygirl.com/diy-custom-closet-shelving/ . These shelves can be used for clothing.