

Related Discussions
Vinyl plank flooring vs pergo (laminate)

I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?

Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?

I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?

I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
Can I remove kitchen cabinet doors that are made of mdf?

My kitchen cabinets (in a ’90s mobile home) are mdf with the paper type covering that rubs off if you scrub too hard. I’ve read that to paint cabinets, it’s goo... See more
Is there a “trick” to getting molded laminate off kitchen doors? T

i have ALOT of upper/lower cabinets and they were covered with that sheeted/molded laminate material. I want to remove it all and paint my cupboards! Has anyone done ... See more
Hi Jeanette, is there any way you could send a photo? It would help us to see what you're dealing with and we could give you more specific tips.
Hi Jeanette, hope this video helps you remove the door latches.
0:24
2:19Suggested clip · 80 seconds
Removing Furniture Hardware Tip - YouTubewww.youtube.com › watch
Hi Jeanette. You should be able to unscrew the screws that are holding the latches in. Either a phillips head screwdriver or a standard screwdriver will do the job. Good luck Jeanette. Stay well.
They should just be screwed on.
They just unscrew from the back with a screwdriver, select the correct one for the job.
They should have screws, but if they're stuck, spray with some WD-40, let it sit for a bit and then try again.
Hi Jeanette: They should just unscrerw. If they are painted over, you will need to remove the paint from the screws. You can do this with a razor knife, blade, etc. Good luck
A photo would help if we are not understanding your question.
I agree with others that they should probably unscrew. An electric drill on reverse might help if you're having trouble getting the screws turning. If they're not screwed on, try posting a picture to give us more information. :-)
Ok will do that