How to fix/repair hing on bathroom door
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How do I fix a peeling laminate door on a bathroom cabinet?
How do I fix my bathroom door frame due to my cats scratching on it?
I have 2 inside cats who aren't declawed. And they are using the bathroom door frame to keep their paws sharp. The frame of my bathroom door looks terrible. Does a... See more
hello Regina this is a relatively easy fix. you will need a small wooden dowel, some white glue and a small saw and maybe a hammer
1. Cut the dowel so that it fits into the hole where the screw will go
2. apply glue to both The dowel and the hole not too much
3. Insert the dowel if it’s tight tap it in with the hammer
4. Allow the glue to dry and then cut the dowel flush with the hole
5. Insert the screw and Voila!
Hope this helps!
hello Regina this is a relatively easy fix. you will need a small wooden dowel, some white glue and a small saw and maybe a hammer
1. Cut the dowel so that it fits into the hole where the screw will go
2. apply glue to both The dowel and the hole not too much
3. Insert the dowel if it’s tight tap it in with the hammer
4. Allow the glue to dry and then cut the dowel flush with the hole
5. Insert the screw and Voila!
Hope this helps!
Use a wood match or even a twig with a bit of wood glue to fill the hole then reinsert the screws
It sounds like the screw is stripped. You should be able to get a new one at a hardware store. Take to old one with you so that you can match it. Fill the hole with wood putty then let it dry. Put in the new screw and you're all set. Wishing you the best.
Take the screw with you to the hardware store and buy new ones that are 2 size fatter and at least 1/2 inch longer.
Remove that side of the hinge an hammer a wooden golf tee into the hole. Cut off the top of the tee with a razor knife. Put the hinge back and drill a pilot hole in the tee. All new wood with no dry time required.
Try this first. Take 3-4 round toothpicks, apply Elmers or carpenters glue to them, stick them in the hole and break them off so they are flush. Let the glue dry and then put your screw back in. Works like a charm.
Fill the hole with toothpicks and tap them in lightly with a hammer before breaking or cutting them off flush with surface, no glue needed. :-)
Using the same concept as the matchstick solution that was mentioned above, you could also use a toothpick (or two, if need be) and break it to a length that’s a tad bit shorter than the depth of the hole. Then you just stick the toothpick piece(s) into the hole and screw the screw back into place. It’s a really quick and easy fix that’s worked great for me every time that I’ve used it. Good luck! :)
Home and Garden DIY Ideas | Hometalk
Put some toothpicks in the hole first to give the screw something to grab onto.