How to seal grouted tile?
I just tiled my bathroom. How long before I can seal it?
Related Discussions
How can I seal peel-and-stick vinyl tile?
I had a pipe burst and had to remove my bathroom floor to get to the plumbing. I replaced the floor and have just installed vinyl tile, peel and stick, and am concern... See more
Is it necessary to seal marble mosaic tile you use on a bathroom floor
Homax Tough as Tile Bathroom Sink, Tub & Tile Repair Screw up!
Hi there. I tried the Homax Tough as Tile product (Bathroom, Sink, Tub & Tile Refinish) on the tiles in my bathroom shower. I waited the 3 hours as mentioned. The fir... See more
How far should tile go in a shower area above a tub??
I have to replace this board with waterproof stuff. I want to then tile the enclosure. How far should the tile go- up to where the edge of the tub is? I would think t... See more
How can I update old 1X1 inch bathroom floor tiles?
I hav very old tiny ceramic tiles. I want to update them without having to do the hard work of removing them. A stencil sounds great but every time I see it it’s on... See more
Can you tile and grout mirrors?
Can you tile mirrors in a shower/bathroom?
How can I make over these bathroom tiles without replacing them?
I am renting an apt so cannot make drastic changes but really want to do something about my bathroom tiles. Can I paint over them or how can I change my bathroom look
Hello Joye, hope this helps you out, 48 to 72 hours
After you've installed new tile, you want to wait at least 48 to 72 hours for the grout to dry and cure. Your grout should be clean and dry and make sure the grout lines are cracked or chipped. If they are, then touch up the grout and then wait an additional 48 to 72 hours before you start sealing the grout.
You should wait 2-3 days to seal it and grout sealer is available at your local hardware or home improvement store.
Allow new grout to cure for 48 to 72 hours before sealing. Existing grout should be cleaned and dried before resealing. Make sure grout lines aren't cracked, chipped, or otherwise compromised before treating with a sealant. If they are, touch up grout and wait the requisite 48 to 72 hours before sealing.
I strongly suggest 2 coats. It is worth the wait.
Hi Joye
Here is some info
https://www.thespruce.com/grout-sealer-definition-1821387
https://www.hunker.com/13400976/how-long-do-you-wait-before-sealing-grout