How do I repair wet plaster?
this Is plaster covering a brick fireplace. Behind some of these areas the plaster is soft and indents when you push on it. No roof source of water entry have been found. How do I repair the wet plaster as it has not hardened overtime and I am concered for mold
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
How do I repair and waterproof plaster walls around a tub ?
I want to install tile around my tub. The walls are plaster, which have been damaged by moisture. I have installed a ceiling vent, and I don't want to replace the pla... See more
How do I repair plaster walls that are crumbling?
I have an older home with plaster walls. I am not looking to spend a lot of money to finish them for painting. I am searching for some suggestions on what to do with ... See more
What is the relative humidity in this room/area? Have you tried running a dehumidifier? The chimney may need repointing, or you may have cracks in the crown area of the chimney, which will require a mason's expertise for repair/rebuilding. The chimney may have damage in an area you yourself cannot see. A chimney repair company will have access to a camera, for this purpose.
It may be that the plaster was mixed with too much water. You may have to remove the plaster with a scraper or by sanding and red0 the wall.
Looks like water is seeping in somewhere above the puffy areas, is it worse after rain? I would scrape off the affected area removing any wet plaster and see if there is any wetness above it or mold starting. If not let it dry thoroughly and re-plaster. If there is you may need to call in a professional.
There might be some hairline cracks in the chimney (assuming this is brick and mortar) or the flashing is beginning to leak.
There must be water coming in from somewhere. Plaster will dry over time. Unless it is just soft because it is powdery from not being mixed properly.
Yes, water MUST be coming from somewhere!
The water IS coming from somewhere!! Scrape off the plaster and have a good look!
Kelly
Here is some info for you
https://johncanningco.com/blog/water-damaged-plaster/
Your water infiltration is most likely due to cracks in chimney mortar, flashing, or the cement "cap". Due to the length of the chimney, you may find damage far above your indoor sightline. When was the last time this chimney was professionally inspected?
I would remove that plaster and see what is behind it. It wouldn't just stay moist like that for no reason. Better to check it out sooner than later so you don't get mold.
I would not try to repair ...There is most likely issue that is why it is wet. Open up that area and see what needs to be repaired there before
Remove it to see if there is a water source. Plaster and sheetrock mud should always be put on in thin coats so it can dry properly. I have tried to put too much mud or caulking into a gap before.
You should be able to sand down and patch it with plaster don’t push to hard it sounds like it’s hollow underneath.then paint it