Creating a raised garden bed – in just a few hours
by
SLS Construction & Building Solutions LLC
(IC: professional)
If you happen to have a couple of hours to spare, you can easily create your own raised gardening bed. Raised beds should not generallybe any wider that four feet, with a minimum of a two foot walkway in-between them. Common lengths are 4', 6', 8', 10', 12', and 16'. I based the steps below on a normal yard with semi- flat ground utilizing one simple 48 SF raised bed.
As I chose a 48 SF bed which was 12' long, I needed 3 – 2×12's @ 12' long (pressure treated), a 1x4x12 (pressure treated) for staking the box to the ground & 1 pound of 2 ½" deck screws. If you have an issue with gophers or other digging vermin, you may consider buying some chicken wire that can be placed at the very bottom of the assembly. Depending on the land & garden soil available you may need to buy some soil or compost (up to 36 Cubic Feet to achieve 9" of suitable planting material in the planter.)
Cut one of the 2×12's and the 1×4 into 3 – 4' segments – next cut the 1×4 section in half at a 45 degree angle – you may wish to make one additional cut to make a cut that looks like this ( > ). This will make it easier to pound it straight into the ground.
2 of the cut 2×12 sections are for the ends and the remaining one is for the center – keeping the pieces flush with each other, use three deck screws at each connection point. The 6 stakes, should be pounded into the ground at the 4 outside corners and on each side of the center support.
This post is based off our original one located here: http://blog.sls-construction.com/2010/creating-a-raised-garden-bed
As I chose a 48 SF bed which was 12' long, I needed 3 – 2×12's @ 12' long (pressure treated), a 1x4x12 (pressure treated) for staking the box to the ground & 1 pound of 2 ½" deck screws. If you have an issue with gophers or other digging vermin, you may consider buying some chicken wire that can be placed at the very bottom of the assembly. Depending on the land & garden soil available you may need to buy some soil or compost (up to 36 Cubic Feet to achieve 9" of suitable planting material in the planter.)
Cut one of the 2×12's and the 1×4 into 3 – 4' segments – next cut the 1×4 section in half at a 45 degree angle – you may wish to make one additional cut to make a cut that looks like this ( > ). This will make it easier to pound it straight into the ground.
2 of the cut 2×12 sections are for the ends and the remaining one is for the center – keeping the pieces flush with each other, use three deck screws at each connection point. The 6 stakes, should be pounded into the ground at the 4 outside corners and on each side of the center support.
This post is based off our original one located here: http://blog.sls-construction.com/2010/creating-a-raised-garden-bed
Enjoyed the project?
Published March 13th, 2013 1:31 PM
Comments
Join the conversation
2 of 39 comments
-
Sandra Cook on May 17, 2013Thank you. My soil is very rocky.
-
-
The Garden Stamp on May 17, 2013We use Organic Mechanics potting soil in our raised bed. Fanastic drainage. Love that stuff.
-
Frequently asked questions
Have a question about this project?