How do I repair my door?
![Mart](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-M-F1C40F.png?size=91x91)
![](https://cdn-fastly.hometalk.com/media/profile/2021/06/12/51443955_1.jpg?size=50x50)
![](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-L-605BE8.png?size=50x50)
![](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-L-59A1F4.png?size=50x50)
Door closes and sounds like it catches but when you pull on the door it opens without turning the knob. How do you fix ‘this issue?
Related Discussions
How to get rid of mice?
![Jessica Hill](https://cdn-fastly.hometalk.com/media/profile/2021/08/22/107358_1.jpg?size=50x50)
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
![Abby](https://cdn-fastly.hometalk.com/media/profile/2021/02/07/50639059_1.jpg?size=50x50)
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
![Sharon](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-S-59A1F4.png?size=50x50)
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
![Frisco's Cards](https://cdn-fastly.hometalk.com/media/profile/2017/01/27/18563525_1.jpg?size=50x50)
How do I fix squeaky hardwood floors?
How do I extend this door?
![Prichinna](https://cdn-fastly.hometalk.com/media/profile/2014/07/28/695904.jpg?size=50x50)
I have these wonderful old doors, they are the right width, too short. How do I make them work?
How do I repair a faded fiberglass exterior door?
![Mark P](https://cdn-fastly.hometalk.com/resources/imgs-responsive/avatar-letters/avatar-M-FF9646.png?size=50x50)
My front door has taken a beating from the sun and parts have faded. What is the best way to repair the finish? Thanks
The metal strike plate in your door frame likely needs to be adjusted. It should be a mater of removing the two screws in it, re-positioning it and then screwing it back in.
Does this happen all of the time or only certain times of the year? I find humidity can effect a door in this way.
It sounds like the door catch isn't popping out far enough to engage the door latch hole. It may be either binding or the alignment may be off. Lube may fix the first problem. A little filing of the latch hole may fix the 2nd problem. Put some chalk or lipstick on the latch to see where it tracks.
Try tightening hinges. I've found that this tends to cause doors not to latch properly even more than issues with the strikeplates. If door is not hanging properly due to loose hinge-plate screws, it will throw off the latch/strikeplate alignment too. If screws won't tighten (over time, the holes can sometimes enlarge and get stripped), remove the screw and make the screwhole tighter by putting a simple wooden toothpick into it with a little wood glue or even white glue. Once dry, cut or break toothpick so it's not protruding beyond the hole and re-attach screw. The toothpick is often enough "filler" to ensure a tightly gripping screw.
Good luck!
Here's help https://www.hometips.com/repair-fix/door-lock-latch-problems.html
Try graphite powder
Alternatively, it is best to use the services of a local locksmith to help you. You can check the site https://www.locksmith-illinois.com/commercial-locksmith/