How do i fix it?

+4
Answered

Just finished spraying my shower pan with Homax unfortunatly it came out rough and dull...did all the cleaning. But due to poor lighting I could not see how i was spraying all the time.

How do i fix the roughness and dull finish?

Thank you


  7 answers
  • GrandmasHouseDIY GrandmasHouseDIY on Jul 14, 2020

    I would try another coat after some light sanding. Sometimes all it takes is a little more time and application.

  • Kathy Gunter Law Kathy Gunter Law on Jul 14, 2020

    Lightly sand and apply another coat. You can use fine steel wool for the sanding. Then wipe so that you have a clean surface.

  • Dee Dee on Jul 14, 2020

    Do not use steel wool, for fear of splinters. Use a light sanding sponge. and spray another coat, it may take more than 2 so be patient



  • Redcatcec Redcatcec on Jul 14, 2020

    Agreed, do not use steel wool as Dee pointed out, metal splinters are no fun. A light sanding sponge should do the trick to make the surface ready for another light coat or more to do the job.

  • lightly sand and apply another coat.

  • Cynthia H Cynthia H on Jul 14, 2020

    Hi! I read the directions on the Homax website. They recommend going over drips and sags with a clean paint brush dipped in isopropyl alcohol, then letting it dry for 3 hours before applying another coat. I don't know for sure, but if additional light was set up, you might be able to catch anything before it hardens. From the website, they also recommend very light coats. I hope you are wearing gloves, goggles and a respirator after reading the warnings and chemicals. Good luck and stay safe!

  • Fernando A Santos Fernando A Santos on Jul 15, 2020

    Thank you all....