Dollar Tree Fall Burlap Wreath

7 Materials
$9
30 Minutes
Easy

Remember my "new" screen door I talked about right here? Well, for Fall I wanted to hang a little wreath on it to jazz it up a bit, but I didn't have any small Fall wreaths. I only had large ones.

Let me show you how I made this sweet little Fall burlap wreath for a little less than $10 using supplies you can get at Dollar Tree.
The fun part about this wreath is that I didn't make any of it permanent.  What I mean is, I can take this all apart and change up the florals for any season or holiday.

You will need the following items to re-create my wreath:

1 - 12 inch wire wreath form
1 - roll of burlap 5-1/2" wide
4 - fall colored floral picks
1 - large clip on sunflower
1 - pipe cleaner or floral wire
Scissors

Optional:Hot glue gun and glue sticks - If you wish to make your wreath permanent and not changeable.
STEP 1:  Fold over the raw end of your burlap and tie a small piece of your pipe cleaner to it as if you were tying the twist tie on a bread bag.
STEP 2:  Pick a starting spot on your wreath near the inside edge (on the back of the wreath form) and tie the burlap on using the same method as above.
STEP 3:  Flip the wreath form back over with front facing you and starting at the inside bottom section, push a small portion of the burlap through to form a small loop.
Continue this step for all three sections like this.
STEP 4:  Push all three sections to the left edge up against the cross bar.  Hold firmly and flip the whole wreath form over to the backside.
STEP 5:  While you continue to hold it, make a twist in the burlap like this.
Now flip it back over and repeat steps 3 and 4 again.

NOTE:  I made two ruffles in each section of the wreath form.  If you want to make it look fuller, create three ruffles in each section.
Just keep going repeating the steps until you reach the other side.
When you reach the beginning again, cut your burlap leaving a small tail to tie off again.
Repeat steps 1 and 2 again to finish it off.
Now, using the floral picks of your choice, decorate as you like.  I simply pushed the stem in through the burlap and tucked the tails in under the wire in the back.  Secure with a small piece of pipe cleaner if needed.  Or, if you're making it a permanent non changeable wreath, hot glue everything in place.
I love how it turned out and it was very easy to create.  You could make one of these burlap wreaths for any season or holiday to jazz up your Farmhouse Decorating.  Just have fun with it!

You can click on the "GO" button below to visit our blog and see how it looks on the "new" screen door if you'd like.

Would you like to see some of my other DIY wreaths that I've made? CLICK RIGHT HERE.

Thanks for looking! :)

Resources for this project:

Roll of Burlap 5-1/2" wide
See all materials
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page. More info

Top Hometalk Projects

Check Out These Wonderful Gift Ideas You Can Do All By Yourself
These Herb Garden Ideas Will Make You Want To Start One Of Your Own
30 Fabulous Wreath Ideas That Will Make Your Neighbors Smile
30 Great Mason Jar Ideas You Have To Try
17 DIY-Inspiring Kitchen Backsplashes
30 Great Ideas For Every Pet Owner!
25 Fabulous Feather Projects That You Don't Want To Miss
DeeDee

Want more details about this and other DIY projects? Check out my blog post!

Go

Have a question about this project?

Join the conversation

Your comment...