How do I refinish a solid hardwood floor?
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
How can I update an ugly kitchen tile floor?
My new house has ugly mauve kitchen tile. Too expensive to rip out. What can I do to update it?
Jacqueline....I would call a professional but I am sure some of the folks on here can give you some great instructions!
Best thing is to rent a floor sander as well as the hand sander for corners. Rental place will sell you the necessary sanding discs or belts you will need. Finish the floor with your choice of stain and/or polyurethane. Might need two coats. It’s not hard but time consuming. The hardest part for me was getting the sander home. I had a VW at the time.
if you try to DIY, be very careful with the sander -- you can ruin the floor in a micro second by improper use .... going against the grain, leaving in one area too long, getting the disk/belt wet .... and the machines are very heavy and can create a LOT of dust -- even with a bag ...
I rented a sander from Lowe's and then used 3 coats of Varathane on them. They still look good after a few years BUT wouldn't do it again. I found it hard not to get tiny air bubbles in the polyurethane as I was applying it.
If you want a very pristine look then go the sanding/varnishing route. I one redid a dining room floor by striping and finishing like you would a piece of furniture. It didn't look new- some marks and traffic patterns remained but it looked appropriate to a 50 year old house.
If it is varnish you will probably require a stronger stripper which will require a wash/rinse. Lacquer or shellac should be able to be done with a refinisher.
Once you make the decision to do something, you can do a small test ares.
PLEASE be sure to follow all safety and ventilation recommendations.
If you have a multi story home and can't carry the professional sander up stairs, you can do it yourself with a rotary sander and multiple sanding disks, starting with 40 grit, then moving up to 80, 100, 120, 220. You will require many disks, shop vac, good knee pads, anti vibration gloves, hearing, respiratory and eye protection, tack cloths, and great focus to work in 3' square sections, count your sanding strokes to insure you don't over sand any area, and many breaks to save your arms and back.
Tight areas can be done with "mouse sander" or by hand. If you have spaces between boards, sweep some saw dust into the spaces as a filler.
Tack cloth well before applying stain and sealant, taking your time to apply long, light coats (avoids bubbles), with a stain/sealant brush or long " Swiffer type" applicator.
You'll need good ventilation when applying stain and multiple coats of sealant.
Be sure to let coats dry completely between coats.
A room measuring 16'x 17' can be done yourself this way, over a few weeks.
Hello,
You will need to sand it down (hire upright sander machine for the purpose) to remove all previous finish and then refinish it with sealer.
The sander can “get away from you” and I would definitely remove the baseboard & shoe.
This is a dusty and lengthy process, with the multiple coats of polyurethane.