pretty simple...either find a matching material and patch it...or a contrasting one to make a statement. If stitching isn't your thing? Use Liquid Stitch....easy peasy !!
Hi Fatima. If you can find the iron on fabric patches... Place one inside each hole adhesive side up. Use an iron on only the half with the longest tear. Use a strong needle and thread on the opposite side of the tear to start pulling the fabric closed. Make sure to keep the patch under from shifting too much. Once you have it pulled closed, iron the entire patch under the tear until it holds. Stitch along your new tear seams to permanently keep them closed.😊
Yeesh you've got a big rip there! I agree that you need to look high and low on the couch for an area that you can cut some fabric out of. Once you know how large a piece you've got, you can then figure out first, can you make both arms look the same? Is there enough to completely cover the entire tear? If so, turn the edges under and use fabric glue so it will never fray. I agree with Karen to use an iron on patch with the adhesive side UP inside the tear to make the fabric stronger there. Then you can stitch or even better, use iron on adhesive to attach the finish patch. Good luck!
I would cut a piece from the back of the sofa,near the bottom and hot glue it on.then cover that bare spot on the back with a similar fabric,also hot glued.
That didn't just happen, the fabric has receded over time, so its either make a decorative patch to sew on.... cat on the arm with a tail hanging over the side hole. or invest in a slip cover.
With the amount that the fabric has already frayed around the edges of the open spaces, and the thinness of the fabric itself, it will be difficult to try to 'pull' it closer together with stitching by hand.
I agree that only a slipcover will hide all the damage, plus help prevent further fraying or disintegration.
If you’re feeling crafty just try to have some fun with it, but some lace and sew it over the holes. Put before you do you have to take some thread and tighten the ripped fabric as close as you can get it so your couch doesn’t rip any more
If you can find a piece of this fabric you can harvest , you could Patch it in by sticking it or sewing it in place. You could ask an Upholsterer to do it for you or to Re-cover the Arms on each side with a Contrast Fabric is the right one is not available.. OR You could buy Covers for Arms. on eBay or other online companies, that will hide the problem. And or you could try and Darn with Wool or Warn or Embroidery Thread. Best wishes.
I saw a rocking motorcycle (as opposed to a rocking horse) made out of wood. It was very expensive, but I think I could make one if I had the plans. Anyone out there... See more
Hi All my DIY friends,I have a dated dresser that I would like to somehow fill in the handle holes on the drawers and add knobs to them. Does anyone have any ideas... See more
I am wanting to lighten up my living room. I have brown stained trim, brown stained ceiling beams and a large brown stained built in bookshelf cabinet which is next... See more
I just bought a new mattress set and my bed is about a foot higher. The problem is I have arthritis, and it's hard for me to climb in. I saw some steps and risers on... See more
The nightstand is made from wood, when inserting the drawer on, the left side of the drawer is not even with the right side of the drawer, in other words the drawer... See more
My wife has wanted me to chalk paint the bed for a long time. I have been putting it off. I finally got around to it and she loves it. What do you think about it?
I need help!!! I moved into my parents 60+ year old house. The kitchen cabinets to my knowledge have the original “varnish“ finish plus 60+ years of greasy kitchen... See more
I decided to paint an older Stained oak round taBle with chalk paint...but now I have a very noticeable line down the middle Of the top where you can add a leaf...it... See more
I have a "high quality" memory foam mattress similar to tempuredic, I can't remember the brand, its either serta or sealy. I bought it back in 2012 and its slowly... See more
Hello everyone. I ordered 4 Billy bookcases to make my walk-in dressing. I want to attach them 2 by 2, one in front of the other so I have a 2 wardrobe units depth 22... See more
How can I clean the grout tiles on my kitchen table. The grout was originally a dark blue. Now it's black. I want to clean the grout, not necessarily give back... See more
It has all these coffee cup rings on it that I can't get off. I've tried Zep clean stone plus and a lot of other cleaners. The zip sure brought out the shine in... See more
I have painted over a dozen pieces of furniture in various colors of FolkArt wax paint, and followed it all up with the same brand of clear wax, and done some... See more
This is a mahogany coffee table that was my parents and I thought I wanted a lighter wood so sanded it down and made a mess. Have kept it for years unfinished.... See more
My outdoor foot stool and matching small table are falling apart. I purchased the plastic wire, however, I cannot find instructions even on YouTube. All instructions... See more
I need some ideas to update this dated chest. I would like to do something other than just paint it. Any style is fine with me since I’m trying to update our decor.... See more
i recently purchased a home and my kitchen cupboards are always tacky and look like they are dirty near the area where you open them. What would cause this, how do I... See more
You patch it or slip cover it. That tear is not something you can just draw together and stitch back up. :-(
pretty simple...either find a matching material and patch it...or a contrasting one to make a statement. If stitching isn't your thing? Use Liquid Stitch....easy peasy !!
Hi Fatima. If you can find the iron on fabric patches... Place one inside each hole adhesive side up. Use an iron on only the half with the longest tear. Use a strong needle and thread on the opposite side of the tear to start pulling the fabric closed. Make sure to keep the patch under from shifting too much. Once you have it pulled closed, iron the entire patch under the tear until it holds. Stitch along your new tear seams to permanently keep them closed.😊
see if you can salvage enough material from the bottom of the couch even if you have to piece it together and use it to patch.
Or cut small pc from bottom and go to fabric shop and find close match and make patches. Then make arm covers for both sides to hide patch.
Yeesh you've got a big rip there! I agree that you need to look high and low on the couch for an area that you can cut some fabric out of. Once you know how large a piece you've got, you can then figure out first, can you make both arms look the same? Is there enough to completely cover the entire tear? If so, turn the edges under and use fabric glue so it will never fray. I agree with Karen to use an iron on patch with the adhesive side UP inside the tear to make the fabric stronger there. Then you can stitch or even better, use iron on adhesive to attach the finish patch. Good luck!
I would cut a piece from the back of the sofa,near the bottom and hot glue it on.then cover that bare spot on the back with a similar fabric,also hot glued.
slip cover is your answer! You could get one under $30 at amazon
That didn't just happen, the fabric has receded over time, so its either make a decorative patch to sew on.... cat on the arm with a tail hanging over the side hole. or invest in a slip cover.
With the amount that the fabric has already frayed around the edges of the open spaces, and the thinness of the fabric itself, it will be difficult to try to 'pull' it closer together with stitching by hand.
I agree that only a slipcover will hide all the damage, plus help prevent further fraying or disintegration.
You could get some coordinating fabric from JoAnns and make arm covers for both sides.
If you’re feeling crafty just try to have some fun with it, but some lace and sew it over the holes. Put before you do you have to take some thread and tighten the ripped fabric as close as you can get it so your couch doesn’t rip any more
Hello there ,
If you can find a piece of this fabric you can harvest , you could Patch it in by sticking it or sewing it in place. You could ask an Upholsterer to do it for you or to Re-cover the Arms on each side with a Contrast Fabric is the right one is not available.. OR You could buy Covers for Arms. on eBay or other online companies, that will hide the problem. And or you could try and Darn with Wool or Warn or Embroidery Thread. Best wishes.