How do I put drawer pulls on dummy drawers?
Related Discussions
Blackout curtains behind vertical blinds
I have two 6' patio doors, and I want to add blackout curtains to keep the sun/cold out. What is the best way to hang them, and what can I use to push the curtains ba... See more
How to make a balloon garland?
Does anyone know how to make a balloon garland or a balloon arch?
How do I replace wicker drawer pulls?
How can I replace broken drawer pulls on a small wicker chest?
How can I make affordable arm covers for new chairs?
I’m redoing my living room and giving it a completely new, slightly glam/modern farmhouse look. Neutral Color scheme will be white, grays, a little black, touches o... See more
How do I decoupage old glass bulb covers from light fixtures?
I need ideas for updating hanging light fixtures in kitchen then have the brass colors and clear glass cone bulb covers. I’d like to decoupage the glass covers ?
How can I refresh an old ugly lampshade?
How can I refresh an old cloth lamp shade that has just gotten stained & ugly over the years. The shade is a strange shape so I need an easy solution. Any ideas? Than... See more
E6000 or PowerGrab adhesive.
There are double sided screws that would go into the drawer and the pull. Check out the sizes at your local home improvement store to see if you can find one that fits your drawer pull.
Good to know
You could also glue the knob on.
Attach the same as drawer pulls if you wish or use a construction adhesive. I would drill them in as if you get bored and want to change the pulls or knobs, it is a project to remove the glued on knobs.
Epoxy glue will work great.
Hi ! Either drill holes and stick the screw end of the drawer pull in and glue down or ideally look for a pull that has a flat bottom and glue down . Use masking tape to hold the knob in place while drying ! I recommend using E6000 glue ! It can be found at any craft store .
A construction adhesive should do the trick.