DIY Vanity Lights
These DIY Vanity Lights were a bargain project that used up a ton of supplies from my basement. The only things I purchased were the used sconces for $7.50. The light looks fantastic, and was 100% worth the effort I put in.
I mostly shopped my basement for this project, grabbing some scrap wood and general electrical supplies.
I started by removing the globe from the sconce base and spray painting all of the pieces a flat black. While those dried, I went to work on the scrap wood.
I cut and sanded the wood piece to size, then planned out where I would place my junction boxes.
I cut holes in the wood for each junction box using a jigsaw.
Then I flipped the board over and carved a groove in the back using a spade bit and a drill press. Theoretically, a router and/or forstner bit would have been better things to use, but I didn't have any of those.
The purpose of the groove is to provide a place for the Romex to run through, so it doesn't just get sandwiched between the board and the wall.
Next I stained the piece and added a mounting hole to each corner.
Finally, I mounted the board to the wall. This was a bit of a process, so check out the full blog post if you're curious how I made sure it was secure, even though I couldn't get my screws into studs.
Then I mounted each sconce to the board. I was getting pretty excited at this point, not going to lie. It was looking even better than I expected!
Finally, I reattached the globes to the base, and added lightbulbs. Then the light was done, and it definitely exceeded my expectations!
Admittedly, this was a bit more complicated of a project than some of my other DIY lighting projects ( this easy teapot lamp was a breeze,) but it was totally worth it in my book!
Enjoyed the project?
Resources for this project:
See all materialsComments
Join the conversation
-
Diana Deiley on May 11, 2023
Impressive! Not only does it look awesome, you're recycling. I love it.
-
-
Sarah Hayden Morris on Sep 19, 2023
Oh my gawd!! Woman, ya got skills!! I’m in awe!! Looks amazing!
-
Frequently asked questions
Have a question about this project?
I love the look! They came out beautifully. I was wondering if the black shade makes a big difference in how the light is cast? Is the light now concentrated straight downward? I guess a mirror effect or metal paint on the inside of the shade could reflect the light a bit more. But I think they’re pretty!
Ditto wondering if the light put out is diminished or just directed straight down.
What did Your junction boxes up to for power