Fitting a Kitchen Plinth
You find the original how-to here.
To finish our utility kitchen off, I installed a kickboard. Also known as a kitchen plinth.
It's made of MDF with a high gloss coating. Note you can buy them at the right depth. However, I cut up large end panel for the job.
So I'll show you how I did it.
First, measure the length you need.
If you're going into a corner, you won't need the full length.
Now masking tape your plinth and transfer the measurement.
Wearing a dust mask, cut with a hand saw. OR even better... cut outside.
Unfortunately for me here in the UK, it was raining!
Measure the height of your kitchen units and repeat.
Tip: avoid cutting it too tight if you ever need to take it off.
You'll probably find it easier with a jigsaw here.
Lay the newly cut plinth in front of the kitchen unit legs and mark centre of each leg.
Extend those pencil marks with a speed square.
Line up a plinth foot clip to the pencil line and draw screw holes before pre-drilling.
Screw on the clip plate.
Slide the matching leg clip into the plates on all of them.
Now push the plinth on and repeat for the other side if needed.
Enjoyed the project?
Resources for this project:
See all materialsComments
Join the conversation
-
-
Gail Cooley on Jul 16, 2021
What a great idea 💡I’m definitely going to do this. I’m thinking that is a lot of storage for my baking sheets. 👍👍👍
-
Frequently asked questions
Have a question about this project?